So I'm considering a hobie bait tank, but having the the toro sprinkled head holding my transducer in place no water can get out.
so it was time for a change. I came across a guy that made a custom mount for his here,
http://www.yakangler.com/forum/21-lo...son-kayak-cuda
After looking it over as well as the Lowrance one I decided it cant be that hard to make one that allows water to
flow out if I do decide to get a Hobie bait tank. The Lowrance uses a plastic piece of all thread as well as a "doughnut" to hold the transducer in place which to me seems like a design flaw.
So I got some 1/16 thick aluminum, a 1/4 dia x 1 inch long stainless nut, bolt and lock washers,
a 3/8 by 3 inch long all thread and the nut to go with it. last a 4 square inch 3/16 thick piece of ABS plastic. After all the measuring this is what I came up with.
I plugged the open scupper filled my current bait tank to the brim and let it drain into the well area as the hose was running keeping the tank level for about 20 mins, it didn't flood and looks like this might be a viable option but
without being on the water I'm not 100% sure that it will drain. So some OTW testing will be needed before I commit to the Hobie.
02-18-2013, 05:24 PM
Threaded Mode