Transducer install - Kayak Fishing Adventures on Big Water’s Edge

maui jim · 06-11-2012, 12:10 PM

I mounted mine in the narrows and its works fine. just make sure its sits level in the hull not tiltin up or down. and goop it good

PegLegFury · 06-11-2012, 12:20 PM

Quote:

Originally Posted by maui jim

I mounted mine in the narrows and its works fine. just make sure its sits level in the hull not tiltin up or down. and goop it good

i wasn't going to goop it in place. I was doing a boxless Duct Seal install so I can transfer between kayaks easier. Just putting a circular wall of duct seal down, putting some water inside, lay the 'ducer inside and wrap duct seal over the top of the 'ducer.
I was thinking about a box/tubberware install but those contours would be difficult to shape

PegLegFury · 06-11-2012, 12:34 PM

Jim, can u describe in detail your install?

06-11-2012, 12:10 PM	#1
maui jim Senior Member Join Date: May 2010 Location: Cypress, CA Posts: 789	I mounted mine in the narrows and its works fine. just make sure its sits level in the hull not tiltin up or down. and goop it good __________________ Last edited by maui jim; 06-11-2012 at 12:12 PM. Reason: added

06-11-2012, 12:34 PM	#3
PegLegFury Member Join Date: May 2012 Posts: 35	Jim, can u describe in detail your install? __________________ Intergalatic Ninja Sultan Last edited by PegLegFury; 06-11-2012 at 12:35 PM. Reason: oops