Hacking Yak II - Kayak Fishing Adventures on Big Water’s Edge

bubblehide · 02-19-2011, 05:38 PM

Bob, you must have read my mind. Actually I plan on glassing in a spot for a H2O proof battery box in the forward upper portion of that hole you see there; for a LION battery (think small size and light weight). The yak came with bulkheads, the forward one I cut out for rod storage. The hole right in front of the seat is for an aftermarket hatch, I simply removed it while doing this project. The second bulkhead is right behind the seat, then there is a very large storage area right behind the seat accessible from a round hatch cover topside and a third bulkhead closing it off to the rest of the rear of the yak. Since the drive housing will span the top and bottom sides of the yak, I don't think I'll need any additional reinforcing; but if necessary I could easily add a center post right in front of the hatch after the fact.

I was going to start working on a mold for a built in bait tank just to the rear of the rear storage; so I can keep the weight low, wind resistance down, always have it available, and have one less thing to tie down. I'll add some vertical rod storage/holders while I'm working on it. Basically, while I'm cutting it up, I want to take the time to turn in into a full fledged fishing machine. Now how do I get someone to donate a new HDS/gps unit

As far as a maiden voyage, I have no idea, it's not a small project, not the first thing on my long list of things to do; but I'm giving it some priority and will continue to plug away at it, weather permitting.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

02-19-2011, 05:38 PM	#9
bubblehide Senior Member Join Date: Jun 2008 Posts: 552	Bob, you must have read my mind. Actually I plan on glassing in a spot for a H2O proof battery box in the forward upper portion of that hole you see there; for a LION battery (think small size and light weight). The yak came with bulkheads, the forward one I cut out for rod storage. The hole right in front of the seat is for an aftermarket hatch, I simply removed it while doing this project. The second bulkhead is right behind the seat, then there is a very large storage area right behind the seat accessible from a round hatch cover topside and a third bulkhead closing it off to the rest of the rear of the yak. Since the drive housing will span the top and bottom sides of the yak, I don't think I'll need any additional reinforcing; but if necessary I could easily add a center post right in front of the hatch after the fact. I was going to start working on a mold for a built in bait tank just to the rear of the rear storage; so I can keep the weight low, wind resistance down, always have it available, and have one less thing to tie down. I'll add some vertical rod storage/holders while I'm working on it. Basically, while I'm cutting it up, I want to take the time to turn in into a full fledged fishing machine. Now how do I get someone to donate a new HDS/gps unit As far as a maiden voyage, I have no idea, it's not a small project, not the first thing on my long list of things to do; but I'm giving it some priority and will continue to plug away at it, weather permitting.