PA 12 and Outback new option - Page 3 - Kayak Fishing Adventures on Big Water’s Edge

TJones · 09-04-2012, 08:32 AM

this conversion will not work on revolution? revo no deep enough i would imagine? to convert you cut out old hatch?

bus kid · 09-04-2012, 08:45 AM

Quote:

Originally Posted by TJones

this conversion will not work on revolution? revo no deep enough i would imagine? to convert you cut out old hatch?

The revo is not wide enough and the contour of the area where the round hatch is would not fit the hatch as its flat. You could however install it in the back length wise.
My concern with the conversion for the out back is the structural integraty of the top deck after you remove all the surface area

Iceman · 09-04-2012, 02:38 PM

Quote:

the structural integraty of the top deck after you remove all the surface area

This would be a problem...........if you cut the hole and then did not install the hatch

JNAST13ST · 09-04-2012, 03:17 PM

How much would it cost to ship it down to San Diego?

JNAST13ST · 09-04-2012, 03:20 PM

Have you tested it yet? Any leaks?

Matar · 09-04-2012, 03:42 PM

Running a hose over it for 20 min and no leaks. Goop was my friend.

Iceman · 09-04-2012, 05:53 PM

Shipping is about $7 for the hatch+85 hatch=$7 hardware+$20 bucket.

porkchopcb · 09-04-2012, 07:09 PM

Sorry I'm new, where do I have to go to drop it off?

Iceman · 09-04-2012, 08:21 PM

OEX Sunset Beach
562-592-0800

Scion619 · 09-05-2012, 01:48 PM

Just got this in yesterday ..... Perfect for storing my plastics !!! Thanks Andy and oex sunset beach!!!!!!

bbarton13 · 09-05-2012, 01:55 PM

i wonder if you would be able to put this hatch on the older pa 14. and get rid of the raised hatch?

Iceman · 09-05-2012, 05:50 PM

You can not swap out the original Pro Anglers hatch for the new rec hatch, even if it was turned sideways it would not work..........I checked for someone awhile back.

Rik · 09-11-2012, 02:43 PM

FYI, The Rec Hatch conversion for the Outback is ONLY for 2013 Outbacks.

Rik · 09-11-2012, 02:46 PM

Quote:

Originally Posted by erinoo

Andy...Does Brent have any of those buckets for the pa 12..???

We will have them at Oceanside when they are in stock. Hobie has them on back order as of today

Rik · 09-11-2012, 02:48 PM

Quote:

Originally Posted by JNAST13ST

They don't have them at mission?

Nope, only Hobie Dealers can carry Hobie Parts.... We will have them at Oceanside when they are back in stock

samualson · 11-19-2012, 05:17 PM

Quote:

Originally Posted by Rik

FYI, The Rec Hatch conversion for the Outback is ONLY for 2013 Outbacks.

I have a 2013 Outback and it is marked for the rectangular hatch, however i also have a 2010 Outback and the area where the rec hatch would go is identical to the 2013 Outback.

The only difference is that the 2013 model is marked in the corners for it but everything else is the same so the hatch should fit Outbacks going back quite a few years, you just have to measure for yourself.

samualson · 11-19-2012, 05:29 PM

Quote:

Originally Posted by Matar

installed just need to fine tune.

Looks good but it also looks like it could be a major pita to open while seated.

Matar · 11-19-2012, 05:50 PM

Quote:

Originally Posted by samualson

Looks good but it also looks like it could be a major pita to open while seated.

Yah not to bad but a pain.

TJones · 11-19-2012, 06:04 PM

Matar · 11-19-2012, 07:42 PM

Quote:

Originally Posted by TJones

A 1/5th

09-04-2012, 08:32 AM	#41
TJones Senior Member Join Date: Jan 2012 Posts: 2,526	? this conversion will not work on revolution? revo no deep enough i would imagine? to convert you cut out old hatch?

09-04-2012, 03:17 PM	#44
JNAST13ST Living Da Dream! Join Date: May 2012 Location: SAN DIEGO Posts: 414	How much would it cost to ship it down to San Diego? __________________ Don't tread on me

09-04-2012, 03:20 PM	#45
JNAST13ST Living Da Dream! Join Date: May 2012 Location: SAN DIEGO Posts: 414	Have you tested it yet? Any leaks? __________________ Don't tread on me

09-04-2012, 05:53 PM	#47
Iceman Administrator Join Date: Mar 2005 Location: 1-2 miles off the point Posts: 6,948	Shipping is about $7 for the hatch+85 hatch=$7 hardware+$20 bucket. __________________

09-04-2012, 08:21 PM	#49
Iceman Administrator Join Date: Mar 2005 Location: 1-2 miles off the point Posts: 6,948	OEX Sunset Beach 562-592-0800 __________________

09-04-2012, 03:42 PM	#46
Matar I am just me. Join Date: Jul 2011 Location: Lake Forest Posts: 135	Running a hose over it for 20 min and no leaks. Goop was my friend.

09-04-2012, 07:09 PM	#48
porkchopcb Junior Join Date: Aug 2012 Posts: 9	Sorry I'm new, where do I have to go to drop it off?

09-05-2012, 01:48 PM	#50
Scion619 Member Join Date: Jun 2012 Posts: 60	Just got this in yesterday ..... Perfect for storing my plastics !!! Thanks Andy and oex sunset beach!!!!!!

09-05-2012, 01:55 PM	#51
bbarton13 Junior Join Date: Sep 2011 Posts: 29	i wonder if you would be able to put this hatch on the older pa 14. and get rid of the raised hatch?

09-05-2012, 05:50 PM	#52
Iceman Administrator Join Date: Mar 2005 Location: 1-2 miles off the point Posts: 6,948	You can not swap out the original Pro Anglers hatch for the new rec hatch, even if it was turned sideways it would not work..........I checked for someone awhile back. __________________

09-11-2012, 02:43 PM	#53
Rik OEX Oceanside Join Date: Aug 2008 Posts: 113	FYI, The Rec Hatch conversion for the Outback is ONLY for 2013 Outbacks. __________________ Artist formerly Known as OEX Oceanside

11-19-2012, 06:04 PM	#59
TJones Senior Member Join Date: Jan 2012 Posts: 2,526	will it hold a six pack