Wetmount install condundrum, Loctite Putty?

[Durwood101]

pics of the transducer

[Hypoxic1]

use a cup of any kind, cut the bottom out, I use a pelican box with the bottom cut out, glue the sides of your cylinder to the bottom of the hull with 5200 available at any west marine. wait 24 hours, then go fish 5200 is without question the best adhesive for a water seal going. fill the cup with water and set your transducer in it. DONE

[Durwood101]

Thnx, sometimes I make things so much more complicated than they need to be....

[dsafety]

For strapping the transducer in place you could glue a couple pad eyes to the hull and use some bungies.

Bob

[Durwood101]

I tried scoring out a section of the rubber cup and the goo did not set like I had wanted it too...........thinking maybe I'm just going to set it in the bottom and add water......I've spent waay too much time on this already. The pad-eyes with goop is a good idea along with the tie downs. That should keep the transducer and well from moving around down there. I'm officially "over" the transducer stuff.....got a live bait tank to finish. My wife is about to strangle me at this point. Some good news though, did manage to get the Hobie off the garage floor, so now it's up to at least a height I can manage working on.

[Jzo]

Originally Posted by Durwood101

My wife is about to strangle me at this point...

I hear you, I thought that I was the only one.

[Durwood101]

There are probably more of us than would care to admit..........