![]() |
|
Home | Forum | Online Store | Information | LJ Webcam | Gallery | Register | FAQ | Community | Calendar | Today's Posts | Search |
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Member
Join Date: Sep 2018
Location: rancho bernardo
Posts: 65
|
bait tank design
I have a design in mind for initial build however can't decide which tote to use. I have bought two shown below. Q1: what is minimum depth in a bait tank given my fishing locations? I am hoping 6" or less is adequate. Q2: what is minimum length and width of a bait tank? I know people use 9.5x9.5 petfood containers. Q3: what is a decent (not ideal) water flow per minute in a 3 galloon bait tank? I am planning to have 1 gallon per minute which means complete volume change over every 3 minutes. Thanks in advance |
![]() |
![]() |
![]() |
#2 |
Brandon
Join Date: Jul 2011
Location: San Diego
Posts: 2,345
|
Either container I should work fine. But your pump speed is a little fast. Is this with a 12 volt battery? You want tank to fill in about 7 minutes. No matter the size. If your current flow rate is with a 12volt switch to a 6 volt and it should be very close.
|
![]() |
![]() |
![]() |
#3 |
Member
Join Date: Sep 2018
Location: rancho bernardo
Posts: 65
|
Yes, I was thinking 12 volt. I've been looking really cheapo pumps off amazon, and the one I expect to get is 12 volt , 5 watt , (~.5 amp). Quoted flow is 240 L/Hr = ~1.0 gallons per minute however this may be over quoted.
Any thoughts on the 6" depth? What is the recommended minimum? I would like to go say 5" if that works. Am I bordering on the tank being too small? |
![]() |
![]() |
![]() |
#4 |
Large Member
Join Date: Jul 2012
Location: La Verne, CA
Posts: 1,004
|
25gph bilge pump running on a 6V is the most common configuration you'll see out there.
|
![]() |
![]() |
![]() |
#5 |
Member
Join Date: Sep 2018
Location: rancho bernardo
Posts: 65
|
Oh and what about color? does it really matter?
Getting antsy! Want to pick one, drill some holes and get started! |
![]() |
![]() |
![]() |
#6 |
Large Member
Join Date: Jul 2012
Location: La Verne, CA
Posts: 1,004
|
One issue I see with the totes are all the edges. You're more likely to beat up your fin baits
|
![]() |
![]() |
![]() |
#7 |
Member
Join Date: Sep 2018
Location: rancho bernardo
Posts: 65
|
|
![]() |
![]() |
![]() |
#8 |
Large Member
Join Date: Jul 2012
Location: La Verne, CA
Posts: 1,004
|
|
![]() |
![]() |
![]() |
#9 | |
Brandon
Join Date: Jul 2011
Location: San Diego
Posts: 2,345
|
Quote:
You can run a 12 volt pump on a 6 volt battery. I was suggesting it because your fill will be too fast with a 12volt if it’s going to fill in 3 minutes. |
|
![]() |
![]() |
![]() |
#10 |
Member
Join Date: Sep 2018
Location: rancho bernardo
Posts: 65
|
About done. Went 6v. I imagine fill is around 5 minutes. I will measure later.
|
![]() |
![]() |
![]() |
#11 |
Banned
Join Date: Sep 2018
Posts: 20
|
Loving this thread! indeed
![]() |
![]() |
![]() |
![]() |
#12 |
Member
Join Date: Sep 2018
Location: rancho bernardo
Posts: 65
|
I measured to pump 1 gallon takes 2 mins 15 seconds which mean ~6:45 fill. I am going to drill drain holes to hold exactly 3 gallons. In retrospect I should've put the inlets lower and not had to trim the lid but hey live and learn.
|
![]() |
![]() |
![]() |
#13 | |
Brandon
Join Date: Jul 2011
Location: San Diego
Posts: 2,345
|
Quote:
Pretty spot on flow rate. Nice work |
|
![]() |
![]() |
![]() |
#14 |
Senior Member
Join Date: Jul 2006
Location: Fullerton
Posts: 1,358
|
Looks good. Keep in mind when you drill the holes that you will be rocking on the water, not sitting on stable dryland. I would suggest drilling them higher than you think they should be. You can always drill more lower. A lot easier than plugging holes that ends up before my too low.
Last edited by Hunters Pa; 02-12-2019 at 10:10 AM. Reason: typo |
![]() |
![]() |
![]() |
#15 |
Senior Member
Join Date: Apr 2014
Posts: 241
|
Kind of curious about why you went with one of those boxes instead of a vittles or pet food type of container?
I am not a bait tank expert, just wondering. |
![]() |
![]() |
![]() |
|
|