65# braid to 50 fluoro

[Hunters Pa]

Heading out on a 2-day tomorrow and treated myself to an almost new accurate 2-speed that has 65 braid. Looking to put on a 50# fluoro leader. So looking for suggestions on knots. While we are at it, at what lb test do you switch what knots you use?

[FARRIER]

Bob sands braid to leader and a spangler for the terminal connection.

[Murray]

If you are fishing for yellows, 30 lb leader will be perfect. I use it with both 65 and 50 lb braid and I can not break it under super load. Much easier to work with as well. Just switched over to the RP(not jr) knot by John Collins and it works great and is very easy to tie. You can youtube it for demo. Good luck.

[Hunters Pa]

Originally Posted by Murray

If you are fishing for yellows, 30 lb leader will be perfect. I use it with both 65 and 50 lb braid and I can not break it under super load. Much easier to work with as well. Just switched over to the jr knot by John Collins and it works great and is very easy to tie. You can youtube it for demo. Good luck.

Thanks. Should have clarified that this is my 50# setup. Already set on 25, 30 and 40 pound setups. This is for the bruisers

[FARRIER]

People use the spangler up to 100 poinds no problem. Small knot with a double wrap around the eye of the hook.

[GabeReal]

My go to knots are the FG knot or tony pena knot for braid to flouro connection. Very thin knots, fg is the thinnest out there, goes thru guides no prob. It is also rated as one of the strongest as well. For tying hooks the san diego jam, is my go to. Tied san diego jam with no prob at 50lbs.

Good Luck!!

[Hunters Pa]

Yeah, I use San Diego or Palomar at the end but was looking for opinions on the fluoro to braid connection for heavier line. Thanks all

[HobieScot]

I have used a uni to uni knot for all my braid to mono/flouro connections for years and never once lost a fish due to the connection

I did have one fail but it was a ten year old knot and was wrapped in a passing boats prop so it would have failed no matter what so I don't consider that one time an actual failure


Sent from my iPhone using Tapatalk

[Phiderman]

RP knot. extremely easy to tie and very small / strong

[Mahigeer]

Here is the FG knot by hand.
http://www.netknots.com/fishing_knots/fg-knot/

See my “what is it” thread for a tool to use for tying this knot.

[Holy Mackerel]

Tony Peña knot

[Fishin' Magician]

John Collins knot. Easy and quick to tie and seems to hold up very well. It's small and goes through the guides easier than some of the other knots that are more bulky.

[Dannowar]

Double uni. Do it with all my braid to flouro connections

[YakDout]

albright will work fine for 50lb just come down on the amount of turns. 6 or 7 should be good.

[tattuna]

I've been using the Alberto knot ( aka RP knot, aka modified Albright knot, aka John Collins knot) for years. I rub chapstick on the braid before tying to make it cinch a lot easier.

https://youtu.be/RiSik3Jqs7M

I recently started using the FG knot for my heavier 80-100 lb leaders for popper fishing. Works great on lighter line too. The FG knot has been tested to be a stronger knot. Just make sure your wraps are tight and it won't fail.

https://youtu.be/pjzUb5QRKuk

[Hunters Pa]

Thanks all.

[Tandem Assassin]

Originally Posted by Fishin' Magician

John Collins knot. Easy and quick to tie and seems to hold up very well. It's small and goes through the guides easier than some of the other knots that are more bulky.

THE JC knot is the best and smallest knot out there. No glasses required to tie it..

[alanw]

+1 JC easy to tie never had a failure.