Anyone know a good machinist? - Kayak Fishing Adventures on Big Water’s Edge

Fiskadoro · 03-12-2012, 01:40 PM

Quote:

Originally Posted by jorluivil

No room for a paddle, gaff or bait tank

Just have to build that bicycle, motorcycle, as a tow vehicle kayak trailer, I've been thinking about for something like five years.

sasha · 03-12-2012, 09:19 PM

Jim I bet you would do a better job then we did. You seem to have better exp in welding then we did and also better EQ for this kind of work. Its also much easier to do then it sounds. We done the rear shaft first and after that the front one. Each one we got right the first time. Paying attention to details is all it takes. A sander to clean up the welds and paint to make it looks good and you are done. Now if you make the wheel base too long i would think you would lose the off road capabilty.

03-12-2012, 09:19 PM	#2
sasha Senior Member Join Date: Sep 2010 Posts: 275	Jim I bet you would do a better job then we did. You seem to have better exp in welding then we did and also better EQ for this kind of work. Its also much easier to do then it sounds. We done the rear shaft first and after that the front one. Each one we got right the first time. Paying attention to details is all it takes. A sander to clean up the welds and paint to make it looks good and you are done. Now if you make the wheel base too long i would think you would lose the off road capabilty.