Xducer on a OK Trident help - Kayak Fishing Adventures on Big Water’s Edge

GregAndrew · 12-31-2011, 08:20 PM

Might be able to make a mount for that pretty simple. Cut off the threaded intake tube from an old through-hull bait pump. Use a rivet or nut and bolt through the holes on your Xducer and a couple matching holes through the threaded pipe. Use the tapered plastic nut and rubber seal that comes with the through-hull pump to cinch it into place. Then just feed the wire through the tube. I would cut the tube off flush with the top of the tapered nut and keep the tube open to allow water to drain. I can provide some pics if you need them.

12-31-2011, 08:20 PM	#2
GregAndrew Senior Member Join Date: Mar 2009 Posts: 2,384	Might be able to make a mount for that pretty simple. Cut off the threaded intake tube from an old through-hull bait pump. Use a rivet or nut and bolt through the holes on your Xducer and a couple matching holes through the threaded pipe. Use the tapered plastic nut and rubber seal that comes with the through-hull pump to cinch it into place. Then just feed the wire through the tube. I would cut the tube off flush with the top of the tapered nut and keep the tube open to allow water to drain. I can provide some pics if you need them.