holes that needs to be plugged

[oneyedeer]

Originally Posted by coxtanker421

i have an outback also. i installed a torqueedo motor on it. the kit came with a plastic cap for covering large holes. motor can be mounted in back of yak or in drive bay , in you want to change install locations and move wiring harness , that is what the cap is for .covers hole more than one inch. contact them . maybe sold separately . very clean . flush mount cap . water tight. it would look professional and of course minimal weight . probably grams. good luck. tight lines , Anthony

The holes i covered was for the controller wiring....for the motor to battery wiring the hole was almost 2inches....I needed a compass and the richie x21 is about that size so i put my dremel to work. I will see if i can get some pics up later

[oneyedeer]

here are the pics the reason i would go with hot glue next time is because the plastic doesn't melt clean which resulted in a dirty smudge but it's functional. Think the hot glue would have been cleaner