Mirage Drive GT Upgrade - Kayak Fishing Adventures on Big Water’s Edge

YakDout · 01-24-2015, 07:24 PM

Built my GT drive today. A couple things that were a PITA were the needle bearings in the sprockets due to their length. I ended up pulling every pin from every bearing to fill will some marine grease. Actually wasn't as bad as I thought it would be. The chains fought me for a bit too. This was my first time doing anything to a mirage drive and I felt it was time to learn what I'm using. Thank you LIPRIPPER for the write up. Followed it and it worked to a tee. And thank you ICEMAN and OEX Sb for the parts. Will follow up once tested on water.

ImageUploadedByTapatalk1422159892.320234.jpg

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

01-24-2015, 07:24 PM	#8
YakDout Brandon Join Date: Jul 2011 Location: San Diego Posts: 2,345	Built my GT drive today. A couple things that were a PITA were the needle bearings in the sprockets due to their length. I ended up pulling every pin from every bearing to fill will some marine grease. Actually wasn't as bad as I thought it would be. The chains fought me for a bit too. This was my first time doing anything to a mirage drive and I felt it was time to learn what I'm using. Thank you LIPRIPPER for the write up. Followed it and it worked to a tee. And thank you ICEMAN and OEX Sb for the parts. Will follow up once tested on water. ImageUploadedByTapatalk1422159892.320234.jpg