03-08-2014, 01:11 PM | #1 |
Senior Member
Join Date: May 2013
Location: San Diego
Posts: 112
|
Boat mechanic?
__________________
-Chops |
03-08-2014, 01:15 PM | #2 |
.......
Join Date: Jan 2009
Posts: 1,509
|
|
03-08-2014, 03:42 PM | #3 |
Senior Member
Join Date: May 2013
Location: San Diego
Posts: 112
|
1998 Johnson 130 hp, two stroke
__________________
-Chops |
03-08-2014, 05:18 PM | #4 |
Senior Member
Join Date: Apr 2010
Posts: 6,856
|
I had a 1996 200HP 2 stroke..........what's wrong with it?
__________________
www.facebook.com/Teamsewer |
03-08-2014, 06:15 PM | #5 |
Senior Member
Join Date: May 2013
Location: San Diego
Posts: 112
|
It starts up fine but it won't go into gear. Forward or reverse doesn't work.
__________________
-Chops |
03-08-2014, 06:35 PM | #6 |
Senior Member
Join Date: Apr 2010
Posts: 6,856
|
The best way to find out if the cable is busted it to remove the cowling, push forward on the throttle and see if it engages the shaft that tells the engine to go forward or reserve(circled in red). If I remember correctly once the shaft engages the engine another cable will take over and control the speed.
__________________
www.facebook.com/Teamsewer |
03-08-2014, 06:50 PM | #7 |
Senior Member
Join Date: Apr 2010
Posts: 6,856
|
I changed those cables on my engine once, it took a few hours to do it but it was because I took my time and was doing it solo. Another thing to check is the shaft that the forward/reverse cable controls, its hard to see it because of the parts that cover it but they are known to go bad. Basically, the way is works is the cable is connected to a plate, that plate is welded onto a shaft and that shaft goes into the engine and when it moves forward or back it engages the engine. Apparently, the weld that holds the plate to the shaft is known to fail after a while because of the pressure that it put on it.
I forgot to ask earlier, but are you able to rev the engine if you push forward or back on the throttle? If its revs but does not engage its safe to say its the cable or the shaft.
__________________
www.facebook.com/Teamsewer Last edited by jorluivil; 03-08-2014 at 08:57 PM. |
03-08-2014, 08:50 PM | #8 |
Senior Member
Join Date: Feb 2014
Location: Carlsbad
Posts: 170
|
My friend's husband is an honest and good boat mechanic. If you like I can send you his number tomorrow.
Sent from my iPhone using Tapatalk
__________________
|
03-09-2014, 10:46 AM | #9 |
Senior Member
Join Date: May 2013
Location: San Diego
Posts: 112
|
This is great. I didn't think I would get this great of a response. Awesome! I have taken the cover off and there's been a neighbor and a man at the boat wash station that have taught me a couple of thing. I took out the drew at the bottom of the prop assembly and the magnet has metal clippings. I'm definitely gonna take ur advice on this. BWE is great!!
__________________
-Chops |
|
|