|
Home | Forum | Online Store | Information | LJ Webcam | Gallery | Register | FAQ | Community | Calendar | Today's Posts | Search |
|
Thread Tools | Display Modes |
11-30-2012, 04:48 PM | #1 |
Emperor
Join Date: May 2009
Location: Buena Park
Posts: 3,649
|
Kayak protection
Heres the front end of my PA....start'n to wear a little.. Try'n to figure out were to place the new keel eazy strip.. With a little bit of heat, this stuff sticks pretty good!!! After finishing the front...I thought I'd take care of the back too....here's before And after.... Hopefully this stuff works out...... at $4 a foot it's not too bad, for what it protects.
__________________
There's nothing colder than yesterday's hotdog. |
11-30-2012, 04:58 PM | #2 |
Senior Member
Join Date: May 2012
Location: The Matrix
Posts: 643
|
Nice! Where'd you pick it up at? Let us know how well it holds up. Mine could use that in the front.
__________________
-Kevin |
11-30-2012, 05:02 PM | #3 |
Senior Member
Join Date: Jul 2010
Location: San Diego
Posts: 209
|
Nice! I've been looking for something like that for my Hobie AI.
|
11-30-2012, 05:10 PM | #4 |
Emperor
Join Date: May 2009
Location: Buena Park
Posts: 3,649
|
I got it directly from the website, Just google keeleazy and it should be the first one that pops up. Hopefully this stuff doesn't peel off the first time I take it out, but I doubt it, looks pretty solid.
__________________
There's nothing colder than yesterday's hotdog. |
11-30-2012, 05:26 PM | #5 |
Administrator
Join Date: Mar 2005
Location: 1-2 miles off the point
Posts: 6,943
|
Tony,
I tried it on some rentals and it did not hold up for very long...........rentals get put through some serious wear and tear though.
__________________
|
11-30-2012, 05:56 PM | #6 |
Senior Member
Join Date: Aug 2007
Location: San Diego
Posts: 143
|
I used keel easy strips on 2 kayaks and they held up well. I did change them out once a year when they start to get tore up. Use a heat gun when applying it helps bond to the hull
|
11-30-2012, 06:17 PM | #7 |
.......
Join Date: Jan 2009
Posts: 1,509
|
Protection is important. I was going to post this in the share your inovations thread.
|
11-30-2012, 06:23 PM | #8 | |
Senior Member
Join Date: May 2012
Location: The Matrix
Posts: 643
|
Quote:
I kid....
__________________
-Kevin |
|
11-30-2012, 07:20 PM | #9 |
Senior Member
Join Date: Jun 2007
Location: East County
Posts: 914
|
Damn. I must be an east county redneck. DUCT TAPE. 3 dollars a roll.
__________________
|
11-30-2012, 07:40 PM | #10 |
Senior Member
Join Date: Apr 2010
Posts: 6,856
|
That stuff was orginally made for boats so I'm sure it will hold up, I'll wait to see what it does for you before I use it on my Outback.
__________________
www.facebook.com/Teamsewer |
11-30-2012, 07:50 PM | #11 |
Senior Member
Join Date: Apr 2010
Location: garden grove
Posts: 308
|
Thanks for the post.my pa is starting to get scraped up from the dana boat launch.man that launch is like a cheese grader on my hull.i will be trying this stuff out.
|
11-30-2012, 08:00 PM | #12 | |
Emperor
Join Date: May 2009
Location: Buena Park
Posts: 3,649
|
Quote:
I thinky bwe should make jims condom project a sticky!
__________________
There's nothing colder than yesterday's hotdog. |
|
11-30-2012, 08:10 PM | #13 |
Senior Member
Join Date: May 2005
Location: oceanside
Posts: 880
|
Looks good Tony. Hope it holds up.
|
11-30-2012, 08:17 PM | #14 |
.......
Join Date: Jan 2009
Posts: 1,509
|
Sticky!!! that's disgusting.
I'd think that it's obvious that's not me from that skinny roadbike 700c tube. Back on topic you can actually take larger bike tube like for a 26x2.125 cut a piece a foot long, cut one side open and trim it into the same type shape used above. You then glue it to your keel using spray contact trim adhesive. I've a friend that does that and it works. (I'm thinking he's not seen the post yet) Inner tube rubber may not last as long but old tubes are free if you cycle a lot (I do) it lasts longer then duct tape, and it's softer then plastic so it won't scratch up your car paint. Last edited by Fiskadoro; 11-30-2012 at 08:39 PM. |
11-30-2012, 10:23 PM | #15 |
Senior Member
Join Date: Jun 2011
Location: San Diego
Posts: 664
|
You can request a free sample on their site. They sent me a 10" strip and I have been using it on the back keel. So far so good.
__________________
Urban Camo Trident 13 |
11-30-2012, 11:37 PM | #16 |
Senior Member
Join Date: Apr 2012
Location: El Cajon, CA
Posts: 132
|
I've been gone for too long! Nice to come back and see this thread Hope all you boys are having fun.
|
12-01-2012, 12:32 AM | #17 |
The Kayak Peddler
Join Date: Aug 2012
Location: North Hollywood
Posts: 591
|
Thanks for sharing, i could use some of this on the back of my yak.
__________________
Keep your rod close, your gaff closer, and your paddle on a leash. |
12-01-2012, 01:15 AM | #18 |
Senior Member
Join Date: Apr 2010
Posts: 6,856
|
Yeah, sure we are.
__________________
www.facebook.com/Teamsewer |
12-01-2012, 08:24 AM | #19 |
CEO of Team Roby
Join Date: Sep 2010
Posts: 905
|
Good stuff there Tony. The price seems right too. I'll have to check it out the next time we hit the water.
|
12-01-2012, 08:48 AM | #20 |
Senior Member
Join Date: Feb 2009
Location: SAN DIEGO
Posts: 1,086
|
After years and years of making kayaks...you would think that all the kayak manufactures would THINK to put extra protection under the kayak were it drags.
Lots of room for improvment still needs to come. |
|
|