Kayak Fishing Adventures on Big Water’s Edge  

Go Back   Kayak Fishing Adventures on Big Water’s Edge > Kayak Fishing Forum - Message Board > General Kayak Fishing Discussion

Reply
 
Thread Tools Display Modes
Old 10-05-2012, 01:11 AM   #1
Sdspeed
Senior Member
 
Join Date: Sep 2012
Location: San Diego
Posts: 732
Question pump for my bait tank

I'm building a small bait tank 3 to 4 gal. Do You guys think this unit will move enough water. I figure I 'd stay with a 12volt unit so I don't have to carry 2 batteries or run a volt drop inline to the water pump to slow it down. Want to build a tank that will fit in the hull in front of me since reaching backwards for bait is a bitch on my body.












DC 12V 6.5L (100GPH) submersible WaterPump


Price: $21.50
Sdspeed is offline   Reply With Quote
Old 10-05-2012, 06:28 AM   #2
jruiz
Large Member
 
Join Date: Jul 2012
Location: La Verne, CA
Posts: 1,011
Is it designed for salt water use? Why not a bilge pump?
jruiz is offline   Reply With Quote
Old 10-05-2012, 06:45 AM   #3
Dennis
Senior Member
 
Dennis's Avatar
 
Join Date: Mar 2005
Location: South of La Jolla...
Posts: 1,193
I would probably stick with an attwood, or rule pump. Is it going to be a through hull bait tank system (probably, by the looks of the pump). Also, if your going to put the bait tank in the hull vs on the deck, make sure you don't take on water and sink.
__________________
Hmmmm.....
Dennis is offline   Reply With Quote
Old 10-05-2012, 07:07 AM   #4
Jimmyz123
Senior Member
 
Jimmyz123's Avatar
 
Join Date: Mar 2010
Location: San Diego
Posts: 2,385
You might be better off with this
http://www.walmart.com/ip/Tsunami-50...r-Kit/11071184
__________________
No better time than being on the water,

God Bless,
JimmyZ

Jimmyz123 is offline   Reply With Quote
Old 10-05-2012, 10:31 AM   #5
Sdspeed
Senior Member
 
Join Date: Sep 2012
Location: San Diego
Posts: 732
Quote:
Originally Posted by Jimmyz123 View Post
That would work.
Sdspeed is offline   Reply With Quote
Old 10-05-2012, 10:49 AM   #6
jruiz
Large Member
 
Join Date: Jul 2012
Location: La Verne, CA
Posts: 1,011
I think a 500GPH at 12V would be too much flow. You would need a really big drain to be able to keep up at 100% duty cycle. Even my rule 360 @ 6V can barely keep up with a 3/4" drain. I'm planning to changeto a 1.5" soon.
jruiz is offline   Reply With Quote
Old 10-05-2012, 12:07 PM   #7
Sdspeed
Senior Member
 
Join Date: Sep 2012
Location: San Diego
Posts: 732
Quote:
Originally Posted by jruiz View Post
I think a 500GPH at 12V would be too much flow. You would need a really big drain to be able to keep up at 100% duty cycle. Even my rule 360 @ 6V can barely keep up with a 3/4" drain. I'm planning to changeto a 1.5" soon.
That's why this pump at 100 gph on 12v should move enough water and I'll only have to carry 1 battery to operate it and my FF.
It can be submerged in saltwater but doesn't have to be.
Sdspeed is offline   Reply With Quote
Old 10-06-2012, 08:16 AM   #8
Jimmyz123
Senior Member
 
Jimmyz123's Avatar
 
Join Date: Mar 2010
Location: San Diego
Posts: 2,385
Quote:
Originally Posted by jruiz View Post
I think a 500GPH at 12V would be too much flow. You would need a really big drain to be able to keep up at 100% duty cycle. Even my rule 360 @ 6V can barely keep up with a 3/4" drain. I'm planning to changeto a 1.5" soon.
This is the one I have used many times with no issues with flow or anything. I think many of the bait tanks use this type of pump. I have seen some using 360GPH but for the most part this one
http://www.attwoodmarine.com/store/p...500gph-12-volt

If you install a spray head that you can control the amount of spray you can cut down the flow, but also think of this. Dines use a lot of Oxygen and the water needs to be circulate well for them to stay alive. Most will use timers to control the inflow so that the pump is not always going. Trust me the 500GPH pump is worth it and at walmart is often only about $20 on it's own.
__________________
No better time than being on the water,

God Bless,
JimmyZ

Jimmyz123 is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


All times are GMT -8. The time now is 04:22 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
© 2002 Big Water's Edge. All rights reserved.