Kayak Fishing Adventures on Big Water’s Edge  

Go Back   Kayak Fishing Adventures on Big Water’s Edge > Kayak Fishing Forum - Message Board > General Kayak Fishing Discussion

Reply
 
Thread Tools Display Modes
Old 04-23-2012, 11:54 PM   #1
Drake
Guest
 
Posts: n/a
Hobie PA not water tight?

When I take breakers over the bow, my tub up front and even sometimes the hull take on water. I wonder if its a matter of getting new seals, or perhaps replacing the bungees up front so they're holding the hatch down tighter?

It's a 2011, so I wouldn't think the seals are bad?

Is it common for water to come in when water comes over?
  Reply With Quote
Old 04-23-2012, 11:54 PM   #2
lowprofile
#1 on fishstick's hitlist
 
lowprofile's Avatar
 
Join Date: May 2011
Location: Sea level
Posts: 1,478
use weather stripping. i use it on my gator hatch on the X factor. i used to get atleast 2 gallons of mystery water, this last time.. i only had the couple ounces i put in there to get the fish finder going. works well.
__________________
MLPA- My Largest Poaching Area
lowprofile is offline   Reply With Quote
Old 04-24-2012, 12:01 AM   #3
JeffB
Senior Member
 
JeffB's Avatar
 
Join Date: Oct 2011
Location: La Jolla
Posts: 1,216
If you take out the tub in the front, you will loose your problem. That tub acts as a buffer and does not allow you a proper seal.
__________________
If you're looking for me I'm
JeffB is offline   Reply With Quote
Old 04-24-2012, 12:07 AM   #4
lowprofile
#1 on fishstick's hitlist
 
lowprofile's Avatar
 
Join Date: May 2011
Location: Sea level
Posts: 1,478
Quote:
Originally Posted by JeffB View Post
If you take out the tub in the front, you will loose your problem. That tub acts as a buffer and does not allow you a proper seal.
trim it or shave it down?
__________________
MLPA- My Largest Poaching Area
lowprofile is offline   Reply With Quote
Old 04-24-2012, 09:01 AM   #5
Yakin
Senior Member
 
Yakin's Avatar
 
Join Date: Mar 2012
Location: San Bernardino, CA
Posts: 913
I have this exact problem this weekend I put my smokes in there and then got half way out popped the hatch and half my smoked were soaked!!
Please if you figure out how to fix it please let me know!!
and I was only in a foot or two of swells and just a few small splashes soaked everything inside of there
__________________
Remember There are Many Fish in the Sea
MEANS MORE TO EAT!!!
Yakin is offline   Reply With Quote
Old 04-24-2012, 10:24 AM   #6
Old Man in the Sea
Senior Member
 
Old Man in the Sea's Avatar
 
Join Date: Feb 2012
Location: Bay Park
Posts: 569
Send a message via Yahoo to Old Man in the Sea
cut the lip off the plastic tub and slide it inside

I used a ryobi cutter to trim the top lip of the tub off so it will slide down inside so you will have a good rubber seal against the lid to prevent water leakage inside...and yes the cigarettes will light better when they are dry...
Old Man in the Sea is offline   Reply With Quote
Old 04-30-2012, 11:18 PM   #7
yani
Guest
 
Posts: n/a
My pro angler took on water thru the front hatch with every surf launch.

Although Gigfish believes every kayak takes on water, thats not true.
I launched my FishnDive hundreds of times thru the surf, and not a drop.

Too bad hobie can't create a better seal for its kayaks.
  Reply With Quote
Old 05-01-2012, 06:55 AM   #8
Yakin
Senior Member
 
Yakin's Avatar
 
Join Date: Mar 2012
Location: San Bernardino, CA
Posts: 913
Quote:
Originally Posted by yani View Post
My pro angler took on water thru the front hatch with every surf launch.

Although Gigfish believes every kayak takes on water, thats not true.
I launched my FishnDive hundreds of times thru the surf, and not a drop.

Too bad hobie can't create a better seal for its kayaks.
Especially what they charge for the PA!
I wasn't launching in surf that big as the video posted above
and my center hatch wasn't filled like that but it had a good inch or two and completely soaked my smokes!!!
__________________
Remember There are Many Fish in the Sea
MEANS MORE TO EAT!!!
Yakin is offline   Reply With Quote
Old 05-01-2012, 08:42 AM   #9
smithers
Member
 
Join Date: Apr 2012
Posts: 39
Bad conditions?

I'm not trying to sound off here; I'm a newb and I know it.

But I'm puzzled by the waves shown in the video. Looks like an experienced kayaker and that surf is considered bad conditions that he wouldn't normally launch in?

My first time ever in the yak was a week back; I launched in waves that were about 2.5 feet and they were bigger coming back in. Yeah, I was a little scared, and yeah, I dumped in shallow water after riding a wave in, but was a great day out overall and I learned a lot. (Next time I won't space out "whee!" when surfing in but will work hard to keep the boat straight)

Just doing a sanity check here; are waves that small really considered "bad conditions"? Was he maybe talking about high wind instead? If I saw dinky waves like that I'd think "perfect!"

Again, I'm not trying to put down the guy in the vid at all. I'm asking because I want to make sure I'm not going to act overconfident. I learned a lot from that video. While I practiced a self-rescue in the pool before going out, I didn't appreciate how hard it might be to flip a boat back over in choppy water. (But a Revo 11 has got to be a lot easier than a PA...) Thanks.
smithers is offline   Reply With Quote
Old 05-01-2012, 03:26 PM   #10
-scallywag-
Banned
 
Join Date: Mar 2009
Location: on the road...
Posts: 598
Quote:
Originally Posted by smithers View Post
Just doing a sanity check here; are waves that small really considered "bad conditions"? Was he maybe talking about high wind instead? If I saw dinky waves like that I'd think "perfect!"

Again, I'm not trying to put down the guy in the vid at all. I'm asking because I want to make sure I'm not going to act overconfident. I learned a lot from that video. While I practiced a self-rescue in the pool before going out, I didn't appreciate how hard it might be to flip a boat back over in choppy water. (But a Revo 11 has got to be a lot easier than a PA...) Thanks.

hahaha...no, not bad conditions....thats maybe 1' wind chop and it doesnt even look like its whitecapping offshore...i really don't see any "surf" but to each his own....with a little practice, fishing in those conditions even with some 2-3' surf thrown in, should be no issue on the revo.

also i have fished a few revos, adventures, and outbacks in the past and never had any serious leakage in the front hatch....if you r getting over a gallon in the hull you may be missing a seal on one of your hatches.
-scallywag- is offline   Reply With Quote
Old 05-01-2012, 08:53 AM   #11
Old Man in the Sea
Senior Member
 
Old Man in the Sea's Avatar
 
Join Date: Feb 2012
Location: Bay Park
Posts: 569
Send a message via Yahoo to Old Man in the Sea
white plastic insert causes leaking - mystery solved...

If you look at the video you will see the front hatch has a white plastic tub with a lip on it. That causes serious leaking because it breaks the seal between the lid and the rubber seal on the kayak. Trim the lip off of the white plastic insert and try the test again...or you can test the theory yourself by putting a long piece of plastic between your car door and the rubber seal and running it through the car wash and then complain that BMW doesn't make a good car cause it leaks on the carpet when I take it through the car wash,,,,
Old Man in the Sea is offline   Reply With Quote
Old 05-01-2012, 09:00 AM   #12
Yakin
Senior Member
 
Yakin's Avatar
 
Join Date: Mar 2012
Location: San Bernardino, CA
Posts: 913
Quote:
Originally Posted by Old Man in the Sea View Post
If you look at the video you will see the front hatch has a white plastic tub with a lip on it. That causes serious leaking because it breaks the seal between the lid and the rubber seal on the kayak. Trim the lip off of the white plastic insert and try the test again...or you can test the theory yourself by putting a long piece of plastic between your car door and the rubber seal and running it through the car wash and then complain that BMW doesn't make a good car cause it leaks on the carpet when I take it through the car wash,,,,
Not to talk down but like I said I own a PA of myself and it comes with the tub.
Hobie should make it to where it has a better latch if they wanted to keep the tub the way it is or make the tub better so it will be sealed a lot better!
it will be just like my t-tops on my camaro they need to make it more water tight and the water gutter line on the t-tops longer so it runs it away from the t-top slats or have no gutter line so it runs with the contour of the car.
Kind of the same lines lie with the hobie PA
__________________
Remember There are Many Fish in the Sea
MEANS MORE TO EAT!!!
Yakin is offline   Reply With Quote
Old 05-01-2012, 09:38 AM   #13
Old Man in the Sea
Senior Member
 
Old Man in the Sea's Avatar
 
Join Date: Feb 2012
Location: Bay Park
Posts: 569
Send a message via Yahoo to Old Man in the Sea
offer you can't refuse?

that is cool... my PA came with the plastic tub so I thought it was after market. and yes would be upset if I paid for it and it didn't say if you buy it your front hatch will start leaking...anyway if any PA owner wants to stop by Bay Park (above mission bay) you can use my Ryobi to trim your tub lip off to make the seal better - pm me it will only takes 10 minutes...
Old Man in the Sea is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


All times are GMT -8. The time now is 05:00 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
© 2002 Big Water's Edge. All rights reserved.