Mirage drive cable tension - Kayak Fishing Adventures on Big Water’s Edge

OEX Sunset Beach · 12-16-2013, 11:11 AM

Snapped cables and chains jumping and taking the top off of some teeth are the most popular fixes that I do in regards to Mirage drives. proper chain and idler pulley cable tension should prevent either of these from happening.

Quote:

Determining if adjustment is needed...
Occasionally the cables may need to be
re-tightened. The cables should be kept
taut; however, the front chain should be a
little tighter than the rear chain. Push with
your thumbs at the points marked (A)
with moderate pressure (see the image
to the right). The side of the chain should
not go beyond the inside edge of the
drum casting

TJones · 12-16-2013, 01:16 PM

for help and advice.

bus kid · 12-16-2013, 04:25 PM

when you hear "that Clicking noise" its too late!

Deamon · 12-16-2013, 05:07 PM

Replace the nylon insert lock nuts whenever you remove or find your self adjusting too much. For the low cost, they'll help keep the cable tension where you want it.

12-16-2013, 01:16 PM	#2
TJones Senior Member Join Date: Jan 2012 Posts: 2,526	thank you for help and advice.

12-16-2013, 04:25 PM	#3
bus kid Team Keine Zugehörigkeit Join Date: Nov 2010 Location: Way out there Posts: 2,854	when you hear "that Clicking noise" its too late! __________________ Não alimente os trolls------------Don't feed the trolls---------------インタネット荒らしを無視しろ

12-16-2013, 05:07 PM	#4
Deamon Senior Member Join Date: Mar 2010 Posts: 1,972	Replace the nylon insert lock nuts whenever you remove or find your self adjusting too much. For the low cost, they'll help keep the cable tension where you want it. __________________ Recreational Fisherman's Catch...2% Commercial Fisherman's Catch- 98% Recreational Fishing Kayakers Catch- .00001% "The reality is that the wall was built to keep all Asians ~specifically Japanese and those that think they're japanese~ out of the U.S"