![]() |
![]() |
#1 |
Work Sucks!
Join Date: Mar 2006
Location: San Diego
Posts: 559
|
power supply
I did charge the battery and reconnected the fish finder and it works. But we all know that working at home and working on the water are two different things. |
![]() |
![]() |
![]() |
#2 |
Senior Member
Join Date: Mar 2005
Location: El Cajon
Posts: 273
|
What kind of ff? Check your manual in the troubleshooting section. You might find your answer there. My unit gives a couple of beeps and also spells out "low voltage" or something to that effect when the battery reaches a volt that I specify.
|
![]() |
![]() |
![]() |
#3 |
Señor member
Join Date: Mar 2005
Location: San Diego, CA
Posts: 1,627
|
I am not sure if it is your battery or FF, but you ought to invest in one of these, much lighter to paddle around than a full size marine battery :shock: ...
http://www.kayakfishinggear.com/cata...ry_3354052.htm or the charger combo... http://www.kayakfishinggear.com/cata...ge_4657019.htm What kind of FF? I have an a Fish Easy II Eagle Electronics, they have great customer service, you may want to call the manufacturer, they may be able to help you over the phone, or give you a return Auth # to send it back. Chris |
![]() |
![]() |
![]() |
#4 |
Member
Join Date: Sep 2005
Location: La Jolla
Posts: 61
|
I was charging my 12V 7Ah battery with a car charger and only getting about 50% capacity or about 3 hours on the FF on a full charge. Switched to one of the small chargers designed for the small batteries and now I get 6 hours plus on the FF (color GPS). Fishfinders are designed with a low battery shut off usually between 10 and 11V, so they will shut down before the pump will. The pump will continue to run below 10V but you will notice it start running slower or has less power the lower it gets. Good luck with it.
|
![]() |
![]() |
![]() |
#5 |
Senior Member
Join Date: Mar 2005
Posts: 719
|
If you are using the same battery for the BT abd the FF... did the BT work? Is so then it's the connection and not the battery. Sometime you need to reseat the head unit, could be a corroded connector. I trying delectric grease on some connectors. MO, from AYS, turned me on to it. I use it in my yak and boat.
|
![]() |
![]() |
![]() |
#6 |
Work Sucks!
Join Date: Mar 2006
Location: San Diego
Posts: 559
|
good advice gents, thanks
|
![]() |
![]() |
![]() |
|
|