|
Home | Forum | Online Store | Information | LJ Webcam | Gallery | Register | FAQ | Community | Calendar | Today's Posts | Search |
|
Thread Tools | Display Modes |
05-20-2010, 03:01 PM | #1 |
Senior Member
Join Date: Apr 2010
Posts: 6,856
|
6V battery charging issues
|
05-20-2010, 03:59 PM | #2 |
Senior Member
Join Date: Apr 2010
Posts: 175
|
The 6v battery may have a higher amh value than the 12v which means it may take a bit longer to charge I believe. I've had batteries take a bit longer than a day to charge fully. Make sure that you have your selector on "6v" and not "12v" too. Throw a voltmeter on it and check it, give it a bit more time, and then if all else fails, then take it back.
|
05-20-2010, 05:01 PM | #3 | |
bing!
Join Date: Mar 2007
Location: socal
Posts: 246
|
Quote:
/bing |
|
05-20-2010, 05:18 PM | #4 |
Olivenhain Bob
Join Date: May 2008
Location: Olivenhain, CA
Posts: 1,121
|
Most batteries get warm while charging. Are you sure you have current going to the battery?
Bob |
05-20-2010, 08:36 PM | #5 |
Senior Member
Join Date: Sep 2006
Location: Bay Ho
Posts: 1,382
|
How many AMPS is the 6 volt ?
-If its a 6 volt 12 amp battery it should be fully charged in a few hours with a 1.5 amp charger. My 6 volt/12 amp always reacted that way. if you're having a problem bring it back. |
05-20-2010, 10:44 PM | #6 |
Senior Member
Join Date: Mar 2009
Posts: 2,384
|
Lots of the less expensive chargers put out 500ma or less. That would mean that a 12ah battery would take 24 hours to fully charge a spent battery. That time could be even longer if the battery or charger terminals are not clean and securely connected. Also, I would not trust that the output of the cheap chargers is accurate. I have had 6v 12ah batteries take 2 days to charge fully due to one or more of these problems.
|
05-21-2010, 08:04 AM | #7 |
Senior Member
Join Date: Apr 2010
Posts: 6,856
|
I just checked the battery and it's at 7.14v but the charger does not indicate a full charge. The paperwork for the charger indicates that the Output Current Rating for 6v is 1.5a with a Maximum Charge Voltage of 7.4v for a 6v battery. Obviously, I've reached the MCV but the charger does not indicate a full charge. I'm confident that I have a good battery so I'm wondering if I should take the charger back and get a better one.
|
05-21-2010, 08:49 AM | #8 | |
.......
Join Date: Jan 2009
Posts: 1,509
|
Quote:
Think about this a minute.. two mechanical objects: one is simple, one is complex.. Which is more likely to malfunction well... the complex one. The real question is....Is it continuing to charge the battery after it's fully charged? Sounds like it is and that is bad news.. You can still use the charger like a manual charger check the voltage and disconnect it when it's done, but just don't expect it's automatic settings to work... Last edited by Fiskadoro; 05-21-2010 at 09:03 AM. |
|
05-21-2010, 04:15 PM | #9 |
Senior Member
Join Date: Apr 2010
Posts: 6,856
|
SURPRISE SURPRISE SURPRISE!!!!!
I got home and found that the charger finally indicated a full charge. I ran my bait pump (Tsunami T500) for about 20min and put the battery back on the charger, a few minutes later it indicated that it was fully charged. Not to happy with the fact that it took almost two days to charge so I'll be returning the charger for something better.........any suggestions? |
|
|