Hobies molded in rod holders - Kayak Fishing Adventures on Big Water’s Edge

OEX Sunset Beach · 04-10-2014, 01:42 PM

not a fan? cut em out and put in deeper flush mounts. This one had cracked from the extension being too tight so I offered up swapping them out on this Outback.

socal.beach.bum · 04-10-2014, 01:44 PM

Good idea. Just picked up a new outback yesterday and that might have to be one of my new projects. After I fix the fish finder issue.

jorluivil · 04-10-2014, 01:47 PM

that's a great idea right der

bosshoss · 04-10-2014, 02:44 PM

Might be my next DIY install right der......

PescadorPete · 04-10-2014, 06:41 PM

Are these angled outboard somewhat so that two trolling rods don't sit parallel? It looks like they are. That's what annoys me about the molded in holders, the lines get twisted together and then get hung up in the rudder. Do you think it works on a Revo?

04-10-2014, 01:42 PM	#1
OEX Sunset Beach Senior Member Join Date: Jun 2013 Posts: 163	Hobies molded in rod holders not a fan? cut em out and put in deeper flush mounts. This one had cracked from the extension being too tight so I offered up swapping them out on this Outback.

04-10-2014, 01:47 PM	#3
jorluivil Senior Member Join Date: Apr 2010 Posts: 6,856	that's a great idea right der __________________ www.facebook.com/Teamsewer

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

04-10-2014, 01:44 PM	#2
socal.beach.bum Senior Member Join Date: Aug 2012 Location: Palos Verde, CA Posts: 636	Good idea. Just picked up a new outback yesterday and that might have to be one of my new projects. After I fix the fish finder issue.

04-10-2014, 02:44 PM	#4
bosshoss Senior Member Join Date: Mar 2012 Location: Santee Posts: 197	Might be my next DIY install right der......

04-10-2014, 06:41 PM	#5
PescadorPete Senior Member Join Date: Mar 2005 Location: Leucadia, CA Posts: 261	Are these angled outboard somewhat so that two trolling rods don't sit parallel? It looks like they are. That's what annoys me about the molded in holders, the lines get twisted together and then get hung up in the rudder. Do you think it works on a Revo?