to all Hobie Outback owners - Kayak Fishing Adventures on Big Water’s Edge

Matar · 07-08-2011, 11:21 AM

From what I am seeing the wedge mount stems are for 1" and smaller holes while the molded in rod holder ID is over and 1-1/4" and just smaller the an 1-1/2". To me these will not work. What i did was take a Peice of 1-1/4" PVC pipe and add a cap. Mount the ball mount to the cap and cut the pipe to legnth. the pipe will be a little sloppy so a little bit of heavy tape and a tight fit.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

07-08-2011, 11:21 AM	#11
Matar I am just me. Join Date: Jul 2011 Location: Lake Forest Posts: 135	From what I am seeing the wedge mount stems are for 1" and smaller holes while the molded in rod holder ID is over and 1-1/4" and just smaller the an 1-1/2". To me these will not work. What i did was take a Peice of 1-1/4" PVC pipe and add a cap. Mount the ball mount to the cap and cut the pipe to legnth. the pipe will be a little sloppy so a little bit of heavy tape and a tight fit.