Battery 168 AMP - Kayak Fishing Adventures on Big Water’s Edge

tagyak · 01-03-2011, 09:29 AM

Quote:

Originally Posted by GregAndrew

Thanks for the batteries Tim (tagyak). When I got them separated they turned out to be (2) 7.2amp batteries. Perfect for standard FF use. Just used a putty knife to separate the 2 sided tape holding the together. They charged right up and topped off with my trickle charger.

glad to they worked out for you. also thanks for getting the amp for these too. lots of people been asking and i really didn't know.

wiredantz · 01-03-2011, 09:50 AM

Thanks for the help Tag, do you know what type of connector i should use to connect it to the battery?

GregAndrew · 01-03-2011, 07:20 PM

I think these are similar to what Tagyak uses to connect his battery to the charger.
http://www.hopkinstowingsolutions.co...extension.html

You cut the wires in half and use one side to connect to your battery and the other side to the FF using simple auto wire connectors on the cut ends. The Sears charger http://www.sears.com/shc/s/p_10153_1...&blockType=G17 has a connector that should connect right to one end (make sure you get the male/female connector polarity correct). Leaving these connectors attached to the tabs on your battery will reduce wear and tear on them too. You can easily use the small alligator clips that come with other chargers on them too.

wiredantz · 01-03-2011, 08:23 PM

thanks this is exactly what i needed

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

01-03-2011, 09:50 AM	#2
wiredantz Currently @ MLO Territory Join Date: Dec 2010 Location: Under the Shadow Posts: 2,290	Thanks for the help Tag, do you know what type of connector i should use to connect it to the battery?

01-03-2011, 07:20 PM	#3
GregAndrew Senior Member Join Date: Mar 2009 Posts: 2,384	I think these are similar to what Tagyak uses to connect his battery to the charger. http://www.hopkinstowingsolutions.co...extension.html You cut the wires in half and use one side to connect to your battery and the other side to the FF using simple auto wire connectors on the cut ends. The Sears charger http://www.sears.com/shc/s/p_10153_1...&blockType=G17 has a connector that should connect right to one end (make sure you get the male/female connector polarity correct). Leaving these connectors attached to the tabs on your battery will reduce wear and tear on them too. You can easily use the small alligator clips that come with other chargers on them too.

01-03-2011, 08:23 PM	#4
wiredantz Currently @ MLO Territory Join Date: Dec 2010 Location: Under the Shadow Posts: 2,290	thanks this is exactly what i needed