No depth reading on the Eagle Cuda??

[Rob929]

How is your ducer mounted? I had inaccurate depth reading after about 50 ft until I switch to a wet mount. (my goop mount turned out to be full of bubbles..)

[Jimmyz123]

is it easy to remount a transducer once it's been gooped?

[Rob929]

I wouldn't say easy.. but not too bad either. Takes a little patience. With mine, the hard part was removing the goop from the transducer. It all pulled off the kayak with some effort, but the goop was really stuck to the ducer. have to carefully scrape and peel it away. A plastic scraper prevented damage to the ducer, and I also tried to weaken the goop with goo gone adhesive remover. Helped a little, and was able to slowly roll and peel it off. I was mainly concerned with getting all the bubbles out..

[dtownfan]

mine is a wet well. i sent it back to hummingbird yesterday. hopefully they send me a new one.

[lamb]

most likely a trasducer problem. I had the same problem 3 times over the years, either with Eagle or smaller Lawrance models (that happen to be compatible with the same transducer).

Each time I orderd a new transducer, installed it, amd I was back in business.

[Sloberdog]

Originally Posted by Rob929

How is your ducer mounted? I had inaccurate depth reading after about 50 ft until I switch to a wet mount. (my goop mount turned out to be full of bubbles..)

I had it gooped in before it died. It was a real pain un-gooping it then cleaning it up. I now have have it wet mounted just under my seat of my Outback. Easy to get to, and super easy to replace or test if ever needed again.