Don't try this - Kayak Fishing Adventures on Big Water’s Edge

twitchy · 07-25-2009, 06:10 PM

This is an example of, "Where there is a will, there is a way".

Love it.

kareem korn · 07-25-2009, 08:24 PM

I think it's an excellent design in prototype material.

T12 · 07-25-2009, 08:24 PM

Great idea, hope round two works out better for you.

bigbarrels · 07-26-2009, 12:09 AM

whose jeep is that? would fit nicely on top of it! Good luck

h2ofishfo · 07-26-2009, 10:16 AM

try abs not pvc

stairman · 07-26-2009, 11:53 AM

sorry to hear about your loss of the truck that happens to many out of work general motors engineers!

fryguy · 07-26-2009, 12:53 PM

Quote:

Looks like it could use an extra support between the post under the seat and the support under the front hatch.

Point taken. The new design is reinforced in these areas and I think I'm gonna use the kayak itself as the main frame. There was too much swaying when I slowed down and caused the pvc glue to break at the joints. I'll be fishin in no time. too bad it's not ready today

punchjamesarnol · 07-26-2009, 03:59 PM

A couple of 1/4 self tapping screws in the joints with the glue would seal the deal! Awesom idea! double thumbs up!

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

07-25-2009, 06:10 PM	#1
twitchy Member Join Date: Apr 2007 Location: Carlsbad, CA Posts: 61	This is an example of, "Where there is a will, there is a way". Love it.

07-25-2009, 08:24 PM	#2
kareem korn Senior Member Join Date: May 2006 Location: C-bad Posts: 431	I think it's an excellent design in prototype material.

07-25-2009, 08:24 PM	#3
T12 Member Join Date: Aug 2007 Location: vista Posts: 36	Great idea, hope round two works out better for you.

07-26-2009, 12:09 AM	#4
bigbarrels Senior Member Join Date: Aug 2008 Location: Vista Posts: 1,111	whose jeep is that? would fit nicely on top of it! Good luck

07-26-2009, 10:16 AM	#5
h2ofishfo Senior Member Join Date: Feb 2007 Location: Santee Posts: 821	try abs not pvc

07-26-2009, 11:53 AM	#6
stairman Member Join Date: Jun 2009 Posts: 84	sorry to hear about your loss of the truck that happens to many out of work general motors engineers!

07-26-2009, 03:59 PM	#8
punchjamesarnol Member Join Date: May 2009 Location: Santuckee Posts: 33	A couple of 1/4 self tapping screws in the joints with the glue would seal the deal! Awesom idea! double thumbs up!