MY Batt. box how to mount it - Kayak Fishing Adventures on Big Water’s Edge

Billy V · 08-29-2008, 09:57 PM

I think it will stick to rough fiberglass. The glue on the back side of good velcro has some serious stick.

I drilled the hole in the lid, then passed the wire through, then cut a rubber grommet and dressed it into the hole.
I added a small dab of marine goop to seal it up.

BTW I just took this shot of the box while the yak was hanging upside down from the rafters. The box stays put unless you remove it.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

08-29-2008, 09:57 PM	#8
Billy V Senior Member Join Date: Sep 2006 Location: Bay Ho Posts: 1,382	I think it will stick to rough fiberglass. The glue on the back side of good velcro has some serious stick. I drilled the hole in the lid, then passed the wire through, then cut a rubber grommet and dressed it into the hole. I added a small dab of marine goop to seal it up. BTW I just took this shot of the box while the yak was hanging upside down from the rafters. The box stays put unless you remove it.