|
09-04-2017, 01:55 PM
|
#11 |
|
Member
Join Date: Nov 2011
Posts: 83
|
Hobie probably thought that jumping up to .312 instead of .281 would eliminate the chance of breaking a fin mast
 Good job on keeping the drill centered  I used a vice and a vertical mill to remove a broken one on a V2 drive last year  In our shop, we have better luck using square drive extractors instead of the spiral type  Tools used 
__________________
Not as much of a Noob w/a PA12 Last edited by IN2DEEP; 09-04-2017 at 09:37 PM. |
|
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode