Kayak Fishing Adventures on Big Water’s Edge  

Go Back   Kayak Fishing Adventures on Big Water’s Edge > Kayak Fishing Forum - Message Board > General Kayak Fishing Discussion

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 05-30-2016, 10:48 PM   #6
pbb
Senior Member
 
pbb's Avatar
 
Join Date: Jul 2013
Location: San Diego
Posts: 149
Quote:
Originally Posted by YTHunter View Post
Buy a 1" wide x 1/4' thick aluminum bar from Home Depot. Use a hacksaw to cut to approximately 3" length. Drill holes to line up with Ram mount, and install with 1/4" x 1" stainless steel bolts and nylon lock nuts.

Thanks. I bought some stainless hardware while I was at West Marine today. I was thinking about bending or filing the washers, as the kayak hull starts to slope down right outside the holes.

But this sounds like a good plan for the backing. Thanks.
__________________
2008 Olive Hobie Revolution 13
pbb is offline   Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


All times are GMT -8. The time now is 04:37 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
© 2002 Big Water's Edge. All rights reserved.