Stern mount transducer on a Revo? - Kayak Fishing Adventures on Big Water’s Edge

Dave Legacy · 05-25-2016, 12:15 PM

I use a ram transducer arm. I was hesitant to go that route as there are a few downsides (risk of hang ups, drag, etc), but I haven't had issues with it yet. I lift it up out of the water when I'm in route to a fishing area then drop the transducer when I want to look around below the kayak. Ideally I'd prefer a molded in transducer pocket on the hull, but the ram mount is fairly practical.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

05-25-2016, 12:15 PM	#7
Dave Legacy Senior Member Join Date: Mar 2015 Location: Hacienda Heights, CA Posts: 427	I use a ram transducer arm. I was hesitant to go that route as there are a few downsides (risk of hang ups, drag, etc), but I haven't had issues with it yet. I lift it up out of the water when I'm in route to a fishing area then drop the transducer when I want to look around below the kayak. Ideally I'd prefer a molded in transducer pocket on the hull, but the ram mount is fairly practical.