Transducer mount... is this right?

[Jimmyz123]

Originally Posted by Subarualmen

Thanks for the feedback. I'll keep an eye on the screws. I will epoxy them and put putty over the epoxy to be safe. I'm a little nervous to solder plastic.

Thanks a bunch!

Welding plastic takes some time, but it's not difficult. I recommend before you even take it out, seal around the area the best you can with epoxy and goop as you've stated, let those set and dry, and then fill the hull full of water and see if anything leaks out. If not, then you should be good to go.