Through the hull wet mount vs glue/goop mount - Kayak Fishing Adventures on Big Water’s Edge

Bert Vega · 07-10-2014, 02:25 PM

I have done the goop. Didn't like it reading not consistent. Could not get all air bubbles out. Then went to plumber putty/duct seal. Worked better but temps were not accurate. Picture was better. Now I am using a wet mount. I think its the best so far and water temp is pretty accurate. No issue with leaking or anything at all. Unless you get direct in the water. The wet mount is the best I have used so far.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

07-10-2014, 02:25 PM	#8
Bert Vega Tail Chaser! Join Date: Dec 2013 Location: Murrieta Posts: 627	I have done the goop. Didn't like it reading not consistent. Could not get all air bubbles out. Then went to plumber putty/duct seal. Worked better but temps were not accurate. Picture was better. Now I am using a wet mount. I think its the best so far and water temp is pretty accurate. No issue with leaking or anything at all. Unless you get direct in the water. The wet mount is the best I have used so far.