Checkout my new seat!!!!!!!!!! - Kayak Fishing Adventures on Big Water’s Edge

samualson · 11-19-2012, 04:55 PM

I modified a boat seat similar to that but the one i used in my Outback was the heavy cushioned type. Even though i sat up higher i also did not notice any problems and it worked great even in rough conditions.

I had four connection points and i replaced the two screw in holders in front of the Outback seat with hobies pad eye screw ins and i clipped the front of the seat (both sides) to those.

I ran a stiff stainless wire through the bottom of the seat which protruded out both sides and i bent them into loops. Those were the connection points up front.

I had two in the back as well. The point is you can do it on an Outback with a little ingenuity.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

11-19-2012, 04:55 PM	#32
samualson Junior Join Date: Oct 2012 Location: NC Posts: 6	I modified a boat seat similar to that but the one i used in my Outback was the heavy cushioned type. Even though i sat up higher i also did not notice any problems and it worked great even in rough conditions. I had four connection points and i replaced the two screw in holders in front of the Outback seat with hobies pad eye screw ins and i clipped the front of the seat (both sides) to those. I ran a stiff stainless wire through the bottom of the seat which protruded out both sides and i bent them into loops. Those were the connection points up front. I had two in the back as well. The point is you can do it on an Outback with a little ingenuity.