Eagle Cuda 350 settings - Kayak Fishing Adventures on Big Waterâ€™s Edge

surf-bum · 03-10-2012, 08:19 AM

I went out to LJ yesterday too. I think I need to remount the transducer. It doesnt seem to give clear chart print outs. The bottom display isnt solid sometimes and is kind of broken up. I was able to mark some ledges in the canyon and even had some specks above the bottom. I dropped bait and got bit so I figure it was working. However even if there were no marks I still got bites. I guess I need to start with the transducer and work from there. Thank you for everyones advice.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

03-10-2012, 08:19 AM	#6
surf-bum Member Join Date: Jun 2011 Posts: 49	I went out to LJ yesterday too. I think I need to remount the transducer. It doesnt seem to give clear chart print outs. The bottom display isnt solid sometimes and is kind of broken up. I was able to mark some ledges in the canyon and even had some specks above the bottom. I dropped bait and got bit so I figure it was working. However even if there were no marks I still got bites. I guess I need to start with the transducer and work from there. Thank you for everyones advice.