Share Your Innovations - Kayak Fishing Adventures on Big Water’s Edge

dsafety · 09-29-2010, 09:03 AM

Fongman, I like the way you think. This is a good idea but it does not fully solve the lack of dry storage problems in Hobies. Raising the platform off the hull is a good first step. The second thing that you have to do is to install barriers on the front and back to keep stuff from sliding out of reach.

I built a similar, (although less elegant) tray for my Revo. I used the lid from a plastic storage container. This lid is approximately 25" x 17" with a 1" lip on the outside edges. To get it to fit through the hatch, I cut it in half. Before shoving the pieces into the kayak, I drilled a few holes on the cut edges. Once the plastic was in place, I ran some zip ties through the holes to reassemble the lid. To finish off, I created a "bulkhead" fore and aft using noodles in hopes that I would be able to keep my gear from sliding out of reach.

My solution is not perfect. The lid slides around a bit and stuff still sometimes slides past the noodle bulkheads. Using your idea of attaching noodle spacers to the bottom of my tray may help keep the thing from sliding around. I know that there is a way to create a better bulkhead which will prevent gear from escaping. I will be thinking about this.

I like your idea. Raising the edges somehow would make it even better. You might also consider drilling some drain holes right under the hatch area since we all know that Hobie hatches sometimes let in a little water when they are opened.

Bob

09-29-2010, 09:03 AM	#11
dsafety Olivenhain Bob Join Date: May 2008 Location: Olivenhain, CA Posts: 1,121	Fongman, I like the way you think. This is a good idea but it does not fully solve the lack of dry storage problems in Hobies. Raising the platform off the hull is a good first step. The second thing that you have to do is to install barriers on the front and back to keep stuff from sliding out of reach. I built a similar, (although less elegant) tray for my Revo. I used the lid from a plastic storage container. This lid is approximately 25" x 17" with a 1" lip on the outside edges. To get it to fit through the hatch, I cut it in half. Before shoving the pieces into the kayak, I drilled a few holes on the cut edges. Once the plastic was in place, I ran some zip ties through the holes to reassemble the lid. To finish off, I created a "bulkhead" fore and aft using noodles in hopes that I would be able to keep my gear from sliding out of reach. My solution is not perfect. The lid slides around a bit and stuff still sometimes slides past the noodle bulkheads. Using your idea of attaching noodle spacers to the bottom of my tray may help keep the thing from sliding around. I know that there is a way to create a better bulkhead which will prevent gear from escaping. I will be thinking about this. I like your idea. Raising the edges somehow would make it even better. You might also consider drilling some drain holes right under the hatch area since we all know that Hobie hatches sometimes let in a little water when they are opened. Bob