Kayak Fishing Adventures on Big Water’s Edge  

Go Back   Kayak Fishing Adventures on Big Water’s Edge > Kayak Fishing Forum - Message Board > General Kayak Fishing Discussion
Home Forum Online Store Information LJ Webcam Gallery Register FAQ Community Calendar Today's Posts Search

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 11-13-2012, 11:03 PM   #1
lowprofile
#1 on fishstick's hitlist
 
lowprofile's Avatar
 
Join Date: May 2011
Location: Sea level
Posts: 1,478
PVC rod holders for hobie?

this weeks project will be rod holders for the PA. just ones to keep them upright while not in use. plan is to fit a piece of pvc or abs into the existing rod holders in the rear then get an elbow and run 2" pipe straight back with 3 T sections on each side with 14" of pipe going straight up to hold the rods. put a 90 on the end and connect the two sides with pipe going across the back. should easily be held in place by the bungee straps back there and keep the deck open for the bait tank (which will not accept rod holders due to the way the sides are slanted) and fish.

has anyone done something similar and know which size pipe fits the rod holders?
__________________
MLPA- My Largest Poaching Area
lowprofile is offline   Reply With Quote
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


All times are GMT -8. The time now is 03:21 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
© 2002 Big Water's Edge. All rights reserved.