Kayak Fishing Adventures on Big Water’s Edge  

Go Back   Kayak Fishing Adventures on Big Water’s Edge > Kayak Fishing Forum - Message Board > General Kayak Fishing Discussion

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 07-24-2017, 10:16 AM   #3
crashcrow
Senior Member
 
Join Date: Aug 2012
Location: Vista, CA
Posts: 122
Quote:
Originally Posted by DanaPT View Post
nice work. That string tie-down may not be enough. the Hobie tank design has the intake and outflow drop into each of the scupper holes. That helps keep the tank more firmly in place.
I was thinking about that. The inlet hose is stuck pretty firmly in the scupper hole, had to heat and lube it really good to even get it in. It holds the front pretty good, any ideas on tying the back down better would be greatly appreciated. How does the self priming setup work? is it just an elbow? I have a one way valve below the boat to prevent backflow, been priming it with my NRS bilge pump at the moment.
crashcrow is offline   Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


All times are GMT -8. The time now is 07:00 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
© 2002 Big Water's Edge. All rights reserved.