Kayak Fishing Adventures on Big Water’s Edge  

Go Back   Kayak Fishing Adventures on Big Water’s Edge > Kayak Fishing Forum - Message Board > General Kayak Fishing Discussion

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 04-22-2008, 07:39 AM   #13
dgax65
Guerro Grande
 
dgax65's Avatar
 
Join Date: Jan 2006
Location: Houston, TX
Posts: 629
Quote:
Originally Posted by aguachico View Post
Dan; that timer is great. Too bad it isn't water proof. It's designed for a console of a boat, that is unless they changed the design. If it is the same one, I went thru 3 of them, the inevitable salt water intrusion has begun...
I had one of those (made by Patriot or Minute Man?) and it started rusting after the first trip. You can waterproof those to a degree. After it is wired up, coat the entire body of the timer switch with liquid electrical tape (Starbrite). It might take a couple of coats. Let it cure for a few days until it sets hard. Then put dielectric grease on the switch shaft and the potentiometer shaft. The last step is to put a rubber boot on the switch. Note: use wire markers so you know what each lead is-the Starbrite covers up all the markings on the switch.

OR......

You can just get one of the timers from Angler's Yak Shack that suits your needs. Their timers are potted and, as far as I can tell, damn near indestructible.
__________________
Douglas Gaxiola
Team No Fish- Amateur Staff
dgax65 is offline   Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


All times are GMT -8. The time now is 06:22 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
© 2002 Big Water's Edge. All rights reserved.