Kayak Fishing Adventures on Big Water’s Edge  

Go Back   Kayak Fishing Adventures on Big Water’s Edge > Kayak Fishing Forum - Message Board > General Kayak Fishing Discussion

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 04-07-2015, 10:09 AM   #1
RedondoSteve
Member
 
RedondoSteve's Avatar
 
Join Date: Jul 2014
Location: Redondo Beach
Posts: 36
PA 12 Trolling Motor setup

Hey All,
Just finished my Watersnake T24 trolling motor project. This should extend my range considerably and save my knees. Its small enough to fit under the seat
so when I get to my spot I'll switch out to the peddle drive and save battery
for return trip. I shortened the shaft about 11" so it sits nice and low. I built a battery tray that fits behind my seat (50 AH AGM). With the battery in place I have to raise the seat to the upper position. I have always used the seat in the low position and hope I don't lessen stability up high. Hope to try it out this weekend. Still going to mount a plug/recept on the front bulkhead for easy power hookup.
Attached Images
File Type: jpg IMG_1724.jpg (41.7 KB, 108 views)
File Type: jpg IMG_1722.jpg (49.9 KB, 106 views)
File Type: jpg IMG_1723.jpg (37.7 KB, 106 views)
File Type: jpg IMG_1726.jpg (44.6 KB, 49 views)

Last edited by RedondoSteve; 04-07-2015 at 04:03 PM.
RedondoSteve is offline   Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


All times are GMT -8. The time now is 04:28 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
© 2002 Big Water's Edge. All rights reserved.