Through the hull wet mount vs glue/goop mount - Kayak Fishing Adventures on Big Water’s Edge

StinkyMatt · 07-10-2014, 12:31 PM

Go to Home Depot

Buy 1 stick of Duct Seal putty 2.99

Clean the surface in the kayak where application will take place

Press the brick of putty slightly onto the kayak surface

Press transducer into the putty.

Done.

Do not create containers, walls or anything else. Don't get cute...just press ducer into putty...done.

Next best thing is to cut a hole in kayak bottom to get the best quality out of your fancy ff. Research this method on this web site.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

07-10-2014, 12:31 PM	#4
StinkyMatt Senior Member Join Date: Jun 2010 Location: Under a bridge Posts: 2,169	Go to Home Depot Buy 1 stick of Duct Seal putty 2.99 Clean the surface in the kayak where application will take place Press the brick of putty slightly onto the kayak surface Press transducer into the putty. Done. Do not create containers, walls or anything else. Don't get cute...just press ducer into putty...done. Next best thing is to cut a hole in kayak bottom to get the best quality out of your fancy ff. Research this method on this web site.