Kayak Fishing Adventures on Big Water’s Edge  

Go Back   Kayak Fishing Adventures on Big Water’s Edge > Kayak Fishing Forum - Message Board > General Kayak Fishing Discussion

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 03-11-2014, 12:18 PM   #10
CheapPelican
Senior Member
 
Join Date: Jun 2011
Location: Too far from the launch.
Posts: 443
I asked one of the guys in the paint department at work and he said that "If the paint is lacquer based, like krylon, use lacquer thinner. Put a couple drops on there and if it is lacquer based, the paint will blister and peel almost immediately, then you can scrape or rub it off with a rag. Use a wet rag to immediately remove any remaining lacquer. Afterwards test the stripped area by scraping it with a screwdriver or nail. If it is not soft or does not scratch easily you should be good."

They use lacquer thinner to remove graffiti from playground slides which could be, or at least is similar to, polyethylene.

Disclaimer: I have no experience with this so do this @ your own risk
__________________
CheapPelican is offline   Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


All times are GMT -8. The time now is 08:18 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
© 2002 Big Water's Edge. All rights reserved.