What size hooks for thresher ? - Kayak Fishing Adventures on Big Water’s Edge

Pampano · 08-21-2011, 08:50 PM

New to kayak fishing. I have been twice to Newport Bay and outside about 1 mile south of the jetty, tons of mackerel. Does any one know what size of hook for thresher to use, how deep, and what kind of bait to us? Any suggestions are greatly appreciated.

danjor · 08-21-2011, 08:55 PM

I am also intrested in this info. If anyone has knowledge to spare.

dorado50 · 08-21-2011, 09:51 PM

I would suggest a 14/0 hook with greenback in 250ft. of water..

Pampano · 08-21-2011, 10:03 PM

Thanks for the info!

taggermike · 08-22-2011, 10:42 AM

Hook size for bait fishing is usually simple; match the hook size to the size of you live bait. You want a hook that the bait fish can swim with and look some what natural. What size macs do you have, 6 inchers or 2 lbers? I use between 3/0 and 6/0 for mac fishing. Mike

Handymansd · 08-22-2011, 11:07 AM

What:
I like to use very large greenbacks with a 7/0 mutu circle and 150# mono leader works well for T's up to 100#s or so. Larger Sharks typically need steel. I have caught them with steel leaders but I seem to have more success with mono for number of bites... go figure.
Fishing with Rapalas and other "Tkillers" is really a questionable practice resulting in mostly tail hookups, not much fun, and I choose to not participate in using them.
While using chum may increases your chances, it may also increase your chances of being targeted by larger model Mako or other denizen of the ocean depths better left alone... or to more stable fishing platforms like a boat with experienced captain.

Where:
I usually have better luck fishing the temp and current breaks as opposed to any certain depths, especially in a yak where the up-dwelling banks are kind of hard to get to. In particular try the lines of debarkation just outside of areas of "dirty" water or low current water. If current and temp breaks are difficult to find the next best bet is to try to target the higher edge of the canyons or where large drop-offs occur. Most Threshers are usually hooked in 100' or better, though smaller juvenile models are typically caught in shallower waters; but as with any fish they can be caught at any depth. The larger models tend to like the bait presentation lower than 30' in my experience, not in the surface column. Just be prepared and be safe when targeting larger sharks even T's can be dangerous at <100#!

Just my 0.02.
Good Luck!

Pampano · 08-22-2011, 02:17 PM

Thanks guys for the great info, new to the sport, and for some reason I find TS a challenge, until I get in deep trouble, than I go back to fish sardines.

Good luck!

Pampano · 08-22-2011, 02:31 PM

Hello Mike,

We caught tons of 6 to 8" Mack just outside the bay in Newport. I was not sure what hook to use. Reading your comments and tips, I will ensure I use the right gear.

Thanks again!

Handymansd · 08-22-2011, 02:43 PM

Quote:

Originally Posted by Pampano

Hello Mike,

We caught tons of 6 to 8" Mack just outside the bay in Newport. I was not sure what hook to use. Reading your comments and tips, I will ensure I use the right gear.

Thanks again!

be sure to put very slight "slits" down the sides of the Macs to give slight amounts of blood without killing your bait.

Pampano · 08-23-2011, 02:20 PM

That's a good tip Handyman! Thanks!

08-21-2011, 08:50 PM	#1
Pampano Junior Join Date: Aug 2011 Posts: 19	What size hooks for thresher ? New to kayak fishing. I have been twice to Newport Bay and outside about 1 mile south of the jetty, tons of mackerel. Does any one know what size of hook for thresher to use, how deep, and what kind of bait to us? Any suggestions are greatly appreciated. Last edited by Pampano; 08-21-2011 at 10:09 PM.

08-22-2011, 11:07 AM	#6
Handymansd Ancient Member Join Date: Feb 2007 Location: On The Water Posts: 935	What: I like to use very large greenbacks with a 7/0 mutu circle and 150# mono leader works well for T's up to 100#s or so. Larger Sharks typically need steel. I have caught them with steel leaders but I seem to have more success with mono for number of bites... go figure. Fishing with Rapalas and other "Tkillers" is really a questionable practice resulting in mostly tail hookups, not much fun, and I choose to not participate in using them. While using chum may increases your chances, it may also increase your chances of being targeted by larger model Mako or other denizen of the ocean depths better left alone... or to more stable fishing platforms like a boat with experienced captain. Where: I usually have better luck fishing the temp and current breaks as opposed to any certain depths, especially in a yak where the up-dwelling banks are kind of hard to get to. In particular try the lines of debarkation just outside of areas of "dirty" water or low current water. If current and temp breaks are difficult to find the next best bet is to try to target the higher edge of the canyons or where large drop-offs occur. Most Threshers are usually hooked in 100' or better, though smaller juvenile models are typically caught in shallower waters; but as with any fish they can be caught at any depth. The larger models tend to like the bait presentation lower than 30' in my experience, not in the surface column. Just be prepared and be safe when targeting larger sharks even T's can be dangerous at <100#! Just my 0.02. Good Luck! __________________ All men are equal before fish. -Herbert Hoover

08-21-2011, 08:55 PM	#2
danjor Senior Member Join Date: Apr 2011 Location: Riverside CA Posts: 673	I am also intrested in this info. If anyone has knowledge to spare.

08-21-2011, 09:51 PM	#3
dorado50 Senior Member Join Date: Mar 2006 Location: La Jolla Shores Posts: 1,626	I would suggest a 14/0 hook with greenback in 250ft. of water..

08-21-2011, 10:03 PM	#4
Pampano Junior Join Date: Aug 2011 Posts: 19	Thanks for the info!

08-22-2011, 10:42 AM	#5
taggermike Senior Member Join Date: May 2007 Location: Chula Vista Posts: 1,589	Hook size for bait fishing is usually simple; match the hook size to the size of you live bait. You want a hook that the bait fish can swim with and look some what natural. What size macs do you have, 6 inchers or 2 lbers? I use between 3/0 and 6/0 for mac fishing. Mike

08-22-2011, 02:17 PM	#7
Pampano Junior Join Date: Aug 2011 Posts: 19	Thanks guys for the great info, new to the sport, and for some reason I find TS a challenge, until I get in deep trouble, than I go back to fish sardines. Good luck!

08-22-2011, 02:31 PM	#8
Pampano Junior Join Date: Aug 2011 Posts: 19	Hello Mike, We caught tons of 6 to 8" Mack just outside the bay in Newport. I was not sure what hook to use. Reading your comments and tips, I will ensure I use the right gear. Thanks again!

08-23-2011, 02:20 PM	#10
Pampano Junior Join Date: Aug 2011 Posts: 19	That's a good tip Handyman! Thanks!