|
Home | Forum | Online Store | Information | LJ Webcam | Gallery | Register | FAQ | Community | Calendar | Today's Posts | Search |
|
Thread Tools | Display Modes |
04-08-2018, 08:12 PM | #1 |
Junior
Join Date: May 2016
Posts: 22
|
My DIY kayak storage cart
It's a little ghetto but it's practical and less expensive than buying one. Plus it’s very mobile and easy to push around the garage where I have very limited space. |
04-09-2018, 08:02 AM | #2 |
Senior Member
Join Date: Jun 2008
Posts: 109
|
very neat. do you mind sharing the materials you used
|
04-09-2018, 09:50 AM | #3 |
Junior
Join Date: May 2016
Posts: 22
|
Not at all, here you go
2 large Harbor Freight furniture Dolly’s ($12ea) 2 10’ x 3” ABS tubes ($20ea) Home Depot 8 sets of 5/16 nuts, bolts, fender washers & lock washers Electrical tape 1/2” extended and standard length ratchet wrenches and sockets 5/16” drill bit 1” drill bit It would be a good idea to have another person help out and take about 2 hours It’s giong to be a pain to get the tube spacing right. I would recommend just resting the tubes on the Dolly’s and then sitting the kayak on top Center it up as best as possible and mark the Dolly’s up where the tube sits with a straight edge Take the kayak off and align the tubes to the marks Drill the 5/16 bit through the tube, move it out of the way then drill through the wood. Take the 1” bit and drill through only the top 5/16” hole of the tube. Put an end bolt in first so you can square thing up as much as possible. then do another end and then the middle bolts. Take the 1/2” extended ratchet socket and insert the bolt head and fender washer. Tape the bolt/washer to the socket with a little tape so it don’t fall out when you put it in the tube and push through past the wood . Don’t tighten until you have the other bolts aligned and in place. Do the same for the other side. Just take your time. |
|
|