Kayak Fishing Adventures on Big Water’s Edge  

Go Back   Kayak Fishing Adventures on Big Water’s Edge > Kayak Fishing Forum - Message Board > General Kayak Fishing Discussion
Home Forum Online Store Information LJ Webcam Gallery Register FAQ Community Calendar Today's Posts Search

Reply
 
Thread Tools Display Modes
Old 06-21-2013, 05:17 PM   #1
doggmann
Junior
 
doggmann's Avatar
 
Join Date: May 2013
Location: San Gabriel Valley, CA
Posts: 21
fishfinder frustrations/help

I had a small humminbird matrix 17 that came with my kayak. It worked fine but i liked the idea of using GPS too. So I took the unit off my boat wasting in the driveway. Low and behold the unit worked but I couldn't get the GPS to work and the unit would only work for a few hours before it would conk out even though the unit used .750 amps/hour and the battery was rated at 12 amp hour. I am throwing my hands up and think a new unit would be the way to go.

Any opinions good or bad on the lowrance elite 4? I figured I'd stay with lowrance since I have some maps for the west coast stored on the SD card from the old unit.
__________________
doggmann is offline   Reply With Quote
Old 06-21-2013, 06:08 PM   #2
alanw
Made in U.S.A.
 
alanw's Avatar
 
Join Date: Oct 2012
Location: Dana Point
Posts: 1,625
You sure your battery is good? I think you should get at least 8.5-9 hours runtime drawing .75a on a 12ah battery.
__________________
Hobie PA 14 ¸.·´¯`·.´¯`·.¸¸.·´¯`·.¸><(((º>
Jackson Kraken ¸.·´¯`·.¸.·´¯`·.´¯`·.¸¸.·´¯`·.¸><(((º>
Malibu X-Factor ¸.·´¯`·.´¯`·.¸¸.·´¯`·.¸><(((º>
Malibu Stealth-12 ¸.·´¯`·.´¯`·.¸¸.·´¯`·.¸><(((º>


Its not a spelling B its a fishing B ~yakjoe
alanw is offline   Reply With Quote
Old 06-21-2013, 06:37 PM   #3
doggmann
Junior
 
doggmann's Avatar
 
Join Date: May 2013
Location: San Gabriel Valley, CA
Posts: 21
It's not the battery. Checked both of them and they're fine. The matrix 17 would go all day on a 5 amp/hour battery. The old lowrance was the battery killer. Since it seemed to not work anyway (GPS and unexplainable overdraw) I figured why dump dough on it when I can get a decent setup and keep myself from pulling my hair out.
__________________
doggmann is offline   Reply With Quote
Old 06-21-2013, 11:01 PM   #4
alanw
Made in U.S.A.
 
alanw's Avatar
 
Join Date: Oct 2012
Location: Dana Point
Posts: 1,625
I'd think about sending it to them for a repair estimate, they may even offer you a new unit for wholesale cost. At least give them a call?
__________________
Hobie PA 14 ¸.·´¯`·.´¯`·.¸¸.·´¯`·.¸><(((º>
Jackson Kraken ¸.·´¯`·.¸.·´¯`·.´¯`·.¸¸.·´¯`·.¸><(((º>
Malibu X-Factor ¸.·´¯`·.´¯`·.¸¸.·´¯`·.¸><(((º>
Malibu Stealth-12 ¸.·´¯`·.´¯`·.¸¸.·´¯`·.¸><(((º>


Its not a spelling B its a fishing B ~yakjoe
alanw is offline   Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


All times are GMT -8. The time now is 06:34 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
© 2002 Big Water's Edge. All rights reserved.