Kayak Fishing Adventures on Big Water’s Edge  

Go Back   Kayak Fishing Adventures on Big Water’s Edge > Kayak Fishing Forum - Message Board > General Kayak Bass Fishing Discussion
Home Forum Online Store Information LJ Webcam Gallery Register FAQ Community Calendar Today's Posts Search

Reply
 
Thread Tools Display Modes
Old 06-21-2018, 06:06 AM   #1
Yakitman
Junior
 
Join Date: Jun 2018
Posts: 1
Yak repair

My scrubber pro kayak slipped out of its tie downs and was dragged down the freeway a little. The rear keel was ground down at a 45 degree angle. A lot odf materal was removed but no hole. Can i build it up with plasic weld or some other material? I just got the kayak last week any help would be appreciated. Thamk you
Yakitman is offline   Reply With Quote
Old 06-21-2018, 04:10 PM   #2
Iceman
Administrator
 
Iceman's Avatar
 
Join Date: Mar 2005
Location: 1-2 miles off the point
Posts: 6,948
If there is no hole and not scary thin, just leave it as is and keep an eye on it for any additional wear. sometimes attempting to weld thin plastic creates a big problem. You could apply an adhesive keel guard or even JB Weld to give you a wear indicator.
__________________
Iceman is offline   Reply With Quote
Old 06-21-2018, 06:34 PM   #3
Master-baiter
Member
 
Master-baiter's Avatar
 
Join Date: Sep 2017
Posts: 60
Can try the gator guard to add a layer and protect that area. I’ve used this on my kayak and it’s rock solid.

https://www.gator-guards.com


Sent from my iPhone using Tapatalk
Master-baiter is offline   Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -8. The time now is 10:03 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
© 2002 Big Water's Edge. All rights reserved.