|
Home | Forum | Online Store | Information | LJ Webcam | Gallery | Register | FAQ | Community | Calendar | Today's Posts | Search |
|
Thread Tools | Display Modes |
|
07-25-2020, 05:39 PM | #1 |
Recruit
Join Date: Jan 2018
Location: Long Beach, CA
Posts: 153
|
Hobie Pedal Drive - Bent Mast
So my mast is bent on the forward fin of my pedal drive.
Everything seems to work fine. Should I leave it? What will happen over time? Any chance of catastrophic failure? |
07-25-2020, 06:34 PM | #2 |
Xcoastie
Join Date: Jun 2013
Location: Westminster
Posts: 285
|
Pull the pin remove the fin. Unscrew the mast and straighten it.
Sent from my iPhone using Tapatalk |
07-25-2020, 09:33 PM | #3 |
Member
Join Date: Aug 2013
Location: Pine Valley when not fishing La Jolla
Posts: 2,642
|
I've had that happen 3 times. Just pull the pin, remove the fin, get a large box end wrench. Slide the box end down to the area of the bend hold the drive with one hand and when the wrench is in the correct area just above the bent use the length of the wrench to bend it straight again. Do not need to always remove the mast. In an emergency you can provably straighten it enough after removing the pin and fin and just using your hands and brace the mirage drive against the ground. No need to replace the mast unless it's cracked or it's been bent in the same place a handful of times.
__________________
MARK ......... 2016 MALIBU X FACTOR, 2020 SOLO SKIFF (Fishing Kayak on Steroids ) |
07-25-2020, 09:55 PM | #4 |
Recruit
Join Date: Jan 2018
Location: Long Beach, CA
Posts: 153
|
Thanks, will do.
|
07-25-2020, 11:31 PM | #5 |
Senior Member
Join Date: Jan 2014
Location: Long beach
Posts: 302
|
Get a new kayak.
|
07-26-2020, 01:42 PM | #6 |
Senior Member
Join Date: Nov 2014
Location: Sfv
Posts: 147
|
You need a mastsectomy...
|
|
|