|
|
|
06-21-2018, 05:06 AM
|
#1 |
|
Junior
Join Date: Jun 2018
Posts: 1
|
Yak repair
My scrubber pro kayak slipped out of its tie downs and was dragged down the freeway a little. The rear keel was ground down at a 45 degree angle. A lot odf materal was removed but no hole. Can i build it up with plasic weld or some other material? I just got the kayak last week any help would be appreciated. Thamk you
|
|
|
|
06-21-2018, 03:10 PM
|
#2 |
|
Administrator
Join Date: Mar 2005
Location: 1-2 miles off the point
Posts: 6,943
|
If there is no hole and not scary thin, just leave it as is and keep an eye on it for any additional wear. sometimes attempting to weld thin plastic creates a big problem. You could apply an adhesive keel guard or even JB Weld to give you a wear indicator.
__________________
 
|
|
|
|
|
06-21-2018, 05:34 PM
|
#3 |
|
Member
Join Date: Sep 2017
Posts: 60
|
Can try the gator guard to add a layer and protect that area. I’ve used this on my kayak and it’s rock solid.
https://www.gator-guards.com Sent from my iPhone using Tapatalk |
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
