Elite 5 hdi problem - Kayak Fishing Adventures on Big Water’s Edge

YakDout · 04-20-2014, 06:09 PM

Hey guys, wondering if anyone had ever run into this problem, or knows what this may be caused by. I have a lowrance elite 5 hdi unit that I am getting vertical lines spread through out the screen. The lines area sometimes there, and sometimes not. When they do appear, I don't lose any quality of picture on my screen, but they are an annoyance. They also clutter the screen. Adjusting the sensitivity does not help when the problem occurs. The transducer is mounted in a lowrance ready bay, however I had the same problems on my last kayak, while the ducer was on a ram ball mount. Could this have something to do with wiring? Interference from something since it comes and goes? Bad unit? I will take a screen shot of the FF next time I am out if I cannot figure out the problem by then.

Thanks

salty pirate · 04-20-2014, 06:24 PM

Was there another ff on anywhere near you?

You could try a few things when this happens
1. turn the ping speed down
2. turn noise to a higher setting
3. turn off any other electronics

Eli

YakDout · 04-20-2014, 06:27 PM

2 other yaks with FF within 30 yards. Sometimes closer. I google image searched lowrance interference and this came up, and looks exactly like my screen when it plagues me

I have tried adjusting ping speed, have also tried unplugging and plugging. Could my VHF do this somehow?

Sent from my iPhone using Tapatalk

salty pirate · 04-20-2014, 06:44 PM

Its the other sounders that are near you. I get the same try changing the frequency to 200hz or 83hz or 50hz or di only if you have it.

The deeper the water the further away you will have to be from other sounders.

YakDout · 04-20-2014, 06:46 PM

Thanks for the response, this may help some other people as well. I am wondering why they weren't complaining of their units acting up.

Sent from my iPhone using Tapatalk

TJones · 04-22-2014, 01:37 PM

throw something at the nearest yak . i agree with changing ping speed or frequency . one possibility is wake or turbulent waters . possibly from your prop wash , like when running at high speeds . you can more than likely eliminate this from the equation if floating on a plastic vessel .

. i am still in the middle of watching this video from dr. sonar , so i could be wrong . it's like using a local guide to try and advance your learning curve . pm me if any locals want to check it out . Big Sammy .

YakDout · 04-22-2014, 01:38 PM

I don't own a boat ...

Sent from my iPhone using Tapatalk

TJones · 04-22-2014, 01:49 PM

poor mans, like the rest of us .

.crazy thing is how much we invest in these things . i hope some of the suggestions above help . what are you running? pa?

YakDout · 04-22-2014, 01:50 PM

Had a revo 13 now pa14

Sent from my iPhone using Tapatalk

Carp · 04-22-2014, 05:09 PM

I have the smaller elite4 hdi I noticed when I was within 50yrds of my buddy (linglifter) I had the same thing happen. This was in 120ft of water during my last LJ trip.
I'm using a lowrance scupper mount.

When we would split up the signal cleared up.

YakDout · 04-22-2014, 05:12 PM

Thanks guys. I have a feeling that the nearby ducer is the culprit. Will make the other guys I fish with, change frequency. 😁

Sent from my iPhone using Tapatalk

WildernessWanker · 04-22-2014, 06:03 PM

That makes sense, last time I was outside Newport some yahoo came by wearing a sheepskin while "baaaing" and my signal got funky. As soon as he paddled over to another group of kayakers the signal cleared right up.

Sent from my SPH-L520 using Tapatalk

Smthtnnr · 04-22-2014, 09:02 PM

Absolutely it's interfence from other sounders. You just have to deal with it or change the frequency, that's often not a good option!

04-20-2014, 06:09 PM	#1
YakDout Brandon Join Date: Jul 2011 Location: San Diego Posts: 2,345	Elite 5 hdi problem Hey guys, wondering if anyone had ever run into this problem, or knows what this may be caused by. I have a lowrance elite 5 hdi unit that I am getting vertical lines spread through out the screen. The lines area sometimes there, and sometimes not. When they do appear, I don't lose any quality of picture on my screen, but they are an annoyance. They also clutter the screen. Adjusting the sensitivity does not help when the problem occurs. The transducer is mounted in a lowrance ready bay, however I had the same problems on my last kayak, while the ducer was on a ram ball mount. Could this have something to do with wiring? Interference from something since it comes and goes? Bad unit? I will take a screen shot of the FF next time I am out if I cannot figure out the problem by then. Thanks

04-22-2014, 01:37 PM	#6
TJones Senior Member Join Date: Jan 2012 Posts: 2,526	cross talk ? throw something at the nearest yak . i agree with changing ping speed or frequency . one possibility is wake or turbulent waters . possibly from your prop wash , like when running at high speeds . you can more than likely eliminate this from the equation if floating on a plastic vessel . . i am still in the middle of watching this video from dr. sonar , so i could be wrong . it's like using a local guide to try and advance your learning curve . pm me if any locals want to check it out . Big Sammy .

04-22-2014, 01:49 PM	#8
TJones Senior Member Join Date: Jan 2012 Posts: 2,526	yes you do poor mans, like the rest of us . .crazy thing is how much we invest in these things . i hope some of the suggestions above help . what are you running? pa?

04-22-2014, 05:09 PM	#10
Carp (⌐■_■)--︻╦╤─ - - - Join Date: Jun 2013 Location: Sandy Eggo Posts: 166	I have the smaller elite4 hdi I noticed when I was within 50yrds of my buddy (linglifter) I had the same thing happen. This was in 120ft of water during my last LJ trip. I'm using a lowrance scupper mount. When we would split up the signal cleared up. __________________ "California.. If it's not illegal it's going to cost ya" -Bob Munden

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

04-20-2014, 06:24 PM	#2
salty pirate Senior Member Join Date: Jan 2011 Location: where the hell is Temecula Posts: 268	Was there another ff on anywhere near you? You could try a few things when this happens 1. turn the ping speed down 2. turn noise to a higher setting 3. turn off any other electronics Eli

04-20-2014, 06:27 PM	#3
YakDout Brandon Join Date: Jul 2011 Location: San Diego Posts: 2,345	2 other yaks with FF within 30 yards. Sometimes closer. I google image searched lowrance interference and this came up, and looks exactly like my screen when it plagues me I have tried adjusting ping speed, have also tried unplugging and plugging. Could my VHF do this somehow? Sent from my iPhone using Tapatalk

04-20-2014, 06:44 PM	#4
salty pirate Senior Member Join Date: Jan 2011 Location: where the hell is Temecula Posts: 268	Its the other sounders that are near you. I get the same try changing the frequency to 200hz or 83hz or 50hz or di only if you have it. The deeper the water the further away you will have to be from other sounders.

04-20-2014, 06:46 PM	#5
YakDout Brandon Join Date: Jul 2011 Location: San Diego Posts: 2,345	Thanks for the response, this may help some other people as well. I am wondering why they weren't complaining of their units acting up. Sent from my iPhone using Tapatalk

04-22-2014, 01:38 PM	#7
YakDout Brandon Join Date: Jul 2011 Location: San Diego Posts: 2,345	I don't own a boat ... Sent from my iPhone using Tapatalk

04-22-2014, 01:50 PM	#9
YakDout Brandon Join Date: Jul 2011 Location: San Diego Posts: 2,345	Had a revo 13 now pa14 Sent from my iPhone using Tapatalk

04-22-2014, 05:12 PM	#11
YakDout Brandon Join Date: Jul 2011 Location: San Diego Posts: 2,345	Thanks guys. I have a feeling that the nearby ducer is the culprit. Will make the other guys I fish with, change frequency. 😁 Sent from my iPhone using Tapatalk

04-22-2014, 06:03 PM	#12
WildernessWanker WildernessWanker Join Date: Mar 2013 Location: Lancaster, CA Posts: 345	That makes sense, last time I was outside Newport some yahoo came by wearing a sheepskin while "baaaing" and my signal got funky. As soon as he paddled over to another group of kayakers the signal cleared right up. Sent from my SPH-L520 using Tapatalk

04-22-2014, 09:02 PM	#13
Smthtnnr Fishing Addict Join Date: Nov 2012 Location: Orange County Posts: 202	Absolutely it's interfence from other sounders. You just have to deal with it or change the frequency, that's often not a good option!