Hummingbird 597

[medina760]

I just got my fishfinder, I was wondering if anybody has any ideas of where to install the transducer. I would prefer through the scupper hole don't wanna drill no holes or put it through the hull. The transducer is kind of big that's what's making it so difficult to figure out!

[mtnbykr2]

check innovations and do a search....lots and lots of answers, I think HB has a scupper mount....

[Jimmyz123]

Originally Posted by medina760

I just got my fishfinder, I was wondering if anybody has any ideas of where to install the transducer. I would prefer through the scupper hole don't wanna drill no holes or put it through the hull. The transducer is kind of big that's what's making it so difficult to figure out!

Humminbird makes a scupper hole tranducer that would make your life easier. What's wrong with shooting through the hull? I've never had any issues with it. If you use Electrical putty it's not permanent and it works great.

[medina760]

I just move my kayak a lot and transport it upside down. So hull setup wouldn't work for me want something more permanent.

[mtnbykr2]

Originally Posted by medina760

I just move my kayak a lot and transport it upside down. So hull setup wouldn't work for me want something more permanent.

then it sounds like you need to do a wet mount and shoot thru hull

[Jimmyz123]

Originally Posted by medina760

I just move my kayak a lot and transport it upside down. So hull setup wouldn't work for me want something more permanent.

Trust me if you use the electrical putty it will not move if you carry it upside down, sideways, or even drop your kayak. When I had my blue Prowler Kayak I litterally dropped it off of my SUV, twice, and the tranducer never moved, and was in perfect condition. When you want to move the ducer you pop it off of the putty and move it. Peal the putty off and you can use the FF on a different kayak or boat. It's not permanent and it's very clean and easy to use. I posted some picks in the Share your Innovations page, however at that time I used a sponge as a frame. After a couple kayaks and FF moves I realized the sponge frame was not needed. If you're in San Diego area I could help you with this and give you some putty. The putty costs less than $2 at Home depot.
John Oast put out a video for the installation. Very easy.
http://http://www.youtube.com/watch?v=3u1d3_UeD3k

[medina760]

I think I might do the hull set up after all. How does it work for you guys? Do you guys still get good accurate readings?

[medina760]

One last question should i use putty or goop the transducer? And would it be better to use the frame? Looks like it'll keep it in place better.

[Jimmyz123]

Originally Posted by medina760

I think I might do the hull set up after all. How does it work for you guys? Do you guys still get good accurate readings?

I have used this system exclusively for the last two Kayaks I have owned and will always recommend this to others. It's easy, accurate, and not permanent.

I have tried the wet mount setup and did not like the readings from that. The foam sponge for a frame is nice but remember it's not needed. Once you stick something to the putty it will hold in place.