Kayak in the garage - need advice - Kayak Fishing Adventures on Big Water’s Edge

old_rookie · 05-21-2011, 09:10 AM

Kayak mounting

Need some advice since my expertise is software not construction.

I'm creating a pulley lift to store my kayak in the garage. I have added 2x4s using lag screws between the joists and rafters for added support. I then bolted on eye bolts 3/8" x 8". When I tested lifting 50 lbs the bolt was bending more than I expected. So I got some 1/2" x 6" eye bolts and noticed the warning: not for overhead loads. But it is rated for 300lbs. I have two sets for each end of the yak so weight should not be an issue. Does this sound like a good set up?

Pic:

05-21-2011, 09:10 AM	#1
old_rookie Senior Member Join Date: Mar 2010 Location: Santee Posts: 904	Kayak in the garage - need advice Kayak mounting Need some advice since my expertise is software not construction. I'm creating a pulley lift to store my kayak in the garage. I have added 2x4s using lag screws between the joists and rafters for added support. I then bolted on eye bolts 3/8" x 8". When I tested lifting 50 lbs the bolt was bending more than I expected. So I got some 1/2" x 6" eye bolts and noticed the warning: not for overhead loads. But it is rated for 300lbs. I have two sets for each end of the yak so weight should not be an issue. Does this sound like a good set up? Pic: Last edited by old_rookie; 05-21-2011 at 11:07 AM. Reason: added pic removed X's

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode