Pulled the transducer off, well first I tried to pull it off but that was not happening. I ended up going to the kitchen and getting a butter knife and started to work it under the goop, marine goop sure is strong. Anyhow I was able to get the transducer off. BTW it's a new transducer, the fish finder is old but still works. The transducer was working up until I installed it with the goop inside the kayak hull.
Here is what it looked like after I took it off the kayak hull.
I see a huge bubble on the right side of the goop, I'm wondering if this might have been the cause. I tested the transducer again and it still works, it definitely has something to do with my install.
I cut out the goop so that you guys could take a look at the huge bubble that was on the right side of the transducer.
Yup, there was definitely a slight angle to the transducer. I'm going to have to go back and re-install or just take it down to OEX and have Andy install it correctly.
Any other feed back would be much appreciated.
Thank you much guys!