I almost didn't get an over-the-side transducer mount, because of a lot of negative feedback from the various forums. Ultimately I'm glad I took a chance on it, because I haven't found the negatives to be that serious. It does pick up some debris that I will periodically need to clear, but I left my transducer arm a little long and the debris has a tendency to move up toward the surface and clear away from the transducer.
I bent the rod in such a way to allow it to sit very tightly to the hull, and I don't really notice much drag. Since I'm paddling (not gracefully either!), not pedaling, I don't really notice the water noise that some complain about. I also swing it up on deck when I'm getting from point-A to point-B. This works well for traveling on the water, but I undoubtly miss out on noticing stuff I might not want to miss! Obviously one wouldn't want to choose this method of transducer mounting over a hull that has a designated recessed mounting point, but it's a good alternative for those of us who don't have that luxury.
I think the Scotty might have an advantage over the RAM arm if it doesn't have slop/flex in it. My ram mount wants to rotate a bit when underway. It's fine because it rotates into the hull, but the spline system on the Scotty I'd imagine really holds it in place well?
Quote:
Originally Posted by MITCHELL
I ended up using a ram mount and flat aluminum bar on my cobra hope there's no interference with metal....on a hook 5
|
A genuine RAM transducer arm is nothing more than an aluminum stock rod with a corrugated plastic cable conduit over it, so I doubt you should have any issue.