Kayak Fishing Adventures on Big Water’s Edge - View Single Post - Easy and Effective upgrades for Hobie Kayaks

mg2969 · 01-15-2008, 06:27 PM

This is my design
Using the sail mast receptacle
However I detached the original base and crafted a double pivot base with a transducer wire pass through

Hope this is helpful

None of the pieces are glued down especially the cap
Sometimes you might need to take a section off to more easily pass the wire

The whole assembly goes into the sail mast receptacle including the pass through wires

Just
1. 1 2ft piece of 1/2 PVC
2. 1 four-way T
3. 4 90deg elbows
4. a 1/2 cap -drilled
5. 4 spare sections of 1/2 pvc l(like 2 in maybe each)
6. 4 in or so piece of 1/2 in pvc

01-15-2008, 06:27 PM	#12
mg2969 Member Join Date: Mar 2007 Location: Long Beach / Lakewood Posts: 85	This is my design Using the sail mast receptacle However I detached the original base and crafted a double pivot base with a transducer wire pass through Hope this is helpful None of the pieces are glued down especially the cap Sometimes you might need to take a section off to more easily pass the wire The whole assembly goes into the sail mast receptacle including the pass through wires Just 1. 1 2ft piece of 1/2 PVC 2. 1 four-way T 3. 4 90deg elbows 4. a 1/2 cap -drilled 5. 4 spare sections of 1/2 pvc l(like 2 in maybe each) 6. 4 in or so piece of 1/2 in pvc __________________ Hobie Mirage Revolution Prowler 13 - Look ma no hands Last edited by mg2969; 01-15-2008 at 08:03 PM.